Worked example
Example: Atmospheric flash. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Juice flow | 260.00 t/h |
| Juice temperature in | 105.00 °C |
| Flash tank pressure (absolute) | 1.0132 bar |
| Boiling-point elevation of the juice | 0.20000 K |
| Juice specific heat | 3.9000 kJ/(kg·K) |
Applying the formula below gives:
| Result | Value |
|---|---|
| Juice boiling point in the tank | 100.17 °C |
| Flash vapour | 2.1685 t/h |
| Flash vapour share of juice | 0.83403 % |
Open this example in the calculator and change any input.
Formula
\(T_b = T_{sat}(p) + BPE, \quad x = \frac{c_p (T_j - T_b)}{h_{fg}(p)}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot m_j\) | Juice flow | kg/s |
| \(T_j\) | Juice temperature in | K |
| \(p\) | Flash tank pressure (absolute) | Pa |
| \(BPE\) | Boiling-point elevation of the juice | K |
| \(c_p\) | Juice specific heat | J/(kg·K) |
| \(T_b\) | Juice boiling point in the tank | K |
| \(\dot m_v\) | Flash vapour | kg/s |
| \(x\) | Flash vapour share of juice | - |
Method and standards
Energy balance.
Where it is used
- Flash tank sizing.
- Clarification troubleshooting.
Common mistakes
- Forgetting BPE at higher brix.
Assumptions and limits
- Adiabatic flash.
- Juice specific heat and boiling-point elevation are separate inputs, not linked to brix: take both for your juice (c_p falls as brix rises). The result is proportional to c_p.
- The latent heat is taken at the water saturation temperature at p rather than at the juice boiling point; the difference is small for BPE below about 1 K.
References
- Energy balance with IAPWS-IF97 saturation and latent heat; boiling-point elevation as input
Questions and answers
Why flash juice before the clarifier?
Boiling releases air bubbles that would float the mud.
Why heat a few degrees above boiling?
To guarantee flashing even as pressure and BPE vary.
Is the vapour used?
Small flows usually go to a condenser or vent.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.