FireCADCalc

Sulphitation: SO₂ Dose and Sulphur Burnt

SO₂ needed per hour from the juice flow and dose, the sulphur burnt to make it (S + O₂ → SO₂) and sulphur per tonne of cane.

Sugar mill and cogeneration

Inputs

Examples: 1000 mg/L on 250 m3/hSyrup sulphitation

Results

Burner efficiency below 100 % (sublimed sulphur) raises the sulphur actually used.

SO₂ needed250.00kg/h
Sulphur burnt (theoretical, complete burning)125.12kg/h
Sulphur per tonne cane0.50048kg/t

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 1000 mg/L on 250 m3/h. The inputs, in the units selected above:

InputValue
Juice flow250.00 m³/h
SO₂ dose on juice1,000.0 mg/L
Crushing rate250.00 t/h

Applying the formula below gives:

ResultValue
SO₂ needed250.00 kg/h
Sulphur burnt (theoretical, complete burning)125.12 kg/h
Sulphur per tonne cane0.50048 kg/t

Open this example in the calculator and change any input.

Formula

\(\dot m_{SO_2} = \dot V_j\,c, \quad \dot m_S = \dot m_{SO_2}\frac{M_S}{M_S + 2 M_O}\)

Variables

Symbol Meaning SI unit
\(\dot V_j\) Juice flow m³/s
\(c\) SO₂ dose on juice kg/m³
\(C\) Crushing rate kg/s
\(\dot m_{SO_2}\) SO₂ needed kg/s
\(\dot m_S\) Sulphur burnt (theoretical, complete burning) kg/s
\(s\) Sulphur per tonne cane kg/kg

Method and standards

Stoichiometry.

Where it is used

  • Sulphitation plant sizing.
  • Chemical consumption reports.

Common mistakes

  • Dose in ppm by mass on a volume basis.

Assumptions and limits

  • Complete combustion: the sulphur is the theoretical minimum; sublimed or unburnt sulphur raises the real use.
  • Juice flow and crushing rate are separate inputs; they are not checked against each other (juice % cane).

References

  • Stoichiometry S + O₂ → SO₂ with IUPAC atomic masses

Questions and answers

How much SO₂ per kg of sulphur?

About 2 kg: the molar masses are 64 and 32.

Why is actual sulphur higher?

Sublimation and incomplete burning in the burner.

Where is SO₂ dosed?

In double sulphitation, to raw juice and again to syrup.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.