FireCADCalc

Filter Press Area and Frames

Filtering area of a plate-and-frame filter press from its frames (Hugot eqn 31.1), the crush it serves at an area per t cane/h, and the frames needed.

Sugar mill and cogeneration

Inputs

Examples: 42 frames 915 mmSyrup press

Hugot Table 31.1: first carbonatation 6–13, second 4–5, syrup 3–5 m² per t cane/h. The table gives no figure for defecation mud: use plant practice.

Results

Each frame filters on both faces. Hugot's cycle: about 3 hours of filling, washing and emptying.

Filtering area70.327m²
Crush the press serves11.721t/h
Area needed600.00m²
Frames needed359.00

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 42 frames 915 mm. The inputs, in the units selected above:

InputValue
Crushing rate100.00 t/h
Number of frames42.000 -
Frame inside height0.91500 m
Frame inside width0.91500 m
Area needed per t cane/h (m² per t/h)6.0000 m²

Applying the formula below gives:

ResultValue
Filtering area70.327 m²
Crush the press serves11.721 t/h
Area needed600.00 m²
Frames needed359.00

Open this example in the calculator and change any input.

Formula

\(S = 2N H L_f, \quad A_S = \frac{S}{r}, \quad N_n = \left\lceil\frac{A r}{2HL_f}\right\rceil\)

Variables

Symbol Meaning SI unit
\(A\) Crushing rate kg/s
\(N\) Number of frames -
\(H\) Frame inside height m
\(L_f\) Frame inside width m
\(r\) Area needed per t cane/h m²
\(S\) Filtering area m²
\(A_S\) Crush the press serves kg/s
\(S_n\) Area needed m²
\(N_n\) Frames needed -

Method and standards

Hugot's area rule.

Where it is used

  • Sizing filter presses.
  • Checking press capacity.

Common mistakes

  • Counting one face per frame.
  • Using the plate size instead of the frame opening.

Assumptions and limits

  • Area per t/h from practice; it is shown in m² per t cane/h. Hugot's table covers carbonatation and syrup filtration, not defecation mud.

References

  • Hugot
  • Handbook of Cane Sugar Engineering
  • 3rd ed. (Elsevier, 1986)
  • ch. 31
  • eqn 31.1 and Table 31.1
  • pp. 469–472

Questions and answers

Why two faces?

Cake builds on both cloths of each frame, so each frame gives twice its face area.

Still used?

In carbonatation and refineries; raw sugar mills use rotary vacuum or belt filters.

A 1016 mm plate?

Its frame opening is about 915 mm, giving 1.7 m² per frame.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.