FireCADCalc

Saccharate Liming: Milk, Juice and Tank (Hugot)

Milk of lime, juice to form saccharate at a sucrose to lime ratio, and the reaction tank volume for a contact time, after Hugot's example (ch. 24, p. 403).

Sugar mill and cogenerationTank and drum

Inputs

Examples: Hugot: 100 TCH, 700 g CaO/t150 TCH

Hugot (Pongola): 700 g CaO/t cane.
15 °Bé milk holds about 148 g CaO/L.
Hugot: above 6.1 : 1; use 7 : 1.

Results

Hugot: keep the saccharate below 58 °C and use it within minutes; 100 t/h at 700 g CaO/t takes about 473 L/h of 15 °Bé milk.

CaO90.000kg/h
Milk of lime750.00L/h
Juice for the saccharate4,913.2L/h
Reaction tank volume0.56632m³

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Hugot: 100 TCH, 700 g CaO/t. The inputs, in the units selected above:

InputValue
Crushing rate100.00 t/h
Lime dose as CaO per tonne cane0.70000 kg/t
CaO in the milk of lime148.00 g/L
Sucrose : CaO ratio7.0000 -
Brix of the juice used15.000 %
Purity of the juice used (apparent)85.000 %
Juice density1,060.0 kg/m³
Contact time5.0000 min

Applying the formula below gives:

ResultValue
CaO70.000 kg/h
Milk of lime472.97 L/h
Juice for the saccharate3,625.6 L/h
Reaction tank volume0.34155 m³

Open this example in the calculator and change any input.

Formula

\(\dot m_{CaO} = d A, \quad \dot V_m = \frac{\dot m_{CaO}}{c}, \quad \dot V_j = \frac{R\,\dot m_{CaO}}{B P \rho_J}, \quad V = (\dot V_m + \dot V_j)t\)

Variables

Symbol Meaning SI unit
\(A\) Crushing rate kg/s
\(d\) Lime dose as CaO per tonne cane kg/kg
\(c\) CaO in the milk of lime kg/m³
\(R\) Sucrose : CaO ratio -
\(B\) Brix of the juice used -
\(P\) Purity of the juice used (apparent) -
\(\rho_J\) Juice density kg/m³
\(t\) Contact time s
\(\dot m_{CaO}\) CaO kg/s
\(\dot V_m\) Milk of lime m³/s
\(\dot V_j\) Juice for the saccharate m³/s
\(V\) Reaction tank volume m³

Method and standards

Hugot's mass balance for saccharate.

Where it is used

  • Designing saccharate tanks.
  • Setting juice and milk flows.

Common mistakes

  • Using hydrated lime weight as CaO.
  • Taking brix for sucrose.

Assumptions and limits

  • Juice sucrose = brix × purity, with the apparent purity normally measured in the factory (pol for sucrose); true purity gives a slightly different juice quantity.

References

  • Hugot
  • Handbook of Cane Sugar Engineering
  • 3rd ed. (Elsevier, 1986)
  • ch. 24
  • saccharate liming
  • pp. 403–404

Questions and answers

Why saccharate liming?

Lime dissolves far better in sugar solution than in water, so it reacts faster and more evenly, and less is needed.

Why at least 6.1 : 1?

Below that ratio insoluble tricalcium saccharate can form.

How long to react?

A few minutes; Hugot's tank holds about 5 minutes of flow.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.