FireCADCalc

Specific Heat of Cane Juice and Syrup

Specific heat of cane juice, syrup or molasses from brix, temperature and purity by Gucker and Ayres (Hugot eqn 30.2), and by Hugot's simple form 1 − 0.006B.

Sugar mill and cogeneration

Inputs

Examples: Mixed juice 16 brix, 70 °CSyrup 65 brix, 60 °C

Results

Above juice brixes use the Gucker and Ayres value: the simple form 1 − 0.006B is a juice formula and runs low for syrups and molasses.

Gucker and Ayres2.8174kJ/(kg·K)
Simple form 1 − 0.006B2.5539kJ/(kg·K)

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Mixed juice 16 brix, 70 °C. The inputs, in the units selected above:

InputValue
Brix16.000 %
Temperature70.000 °C
Purity85.000 %

Applying the formula below gives:

ResultValue
Gucker and Ayres3.8612 kJ/(kg·K)
Simple form 1 − 0.006B3.7849 kJ/(kg·K)

Open this example in the calculator and change any input.

Formula

\(c_{GA} = 1 - [0.6 - 0.0018t + 0.0008(100 - P)]\frac{B}{100}, \quad c_s = 1 - 0.006B \;[\mathrm{kcal/(kg\,^\circ C)};\ B, P\ \%;\ t\ ^\circ C]\)

Variables

Symbol Meaning SI unit
\(B\) Brix -
\(t\) Temperature K
\(P\) Purity -
\(c_{GA}\) Gucker and Ayres J/(kg·K)
\(c_s\) Simple form 1 − 0.006B J/(kg·K)

Method and standards

Empirical formulae cited by Hugot.

Where it is used

  • Heater and evaporator heat balances.
  • Pan and crystalliser calculations.

Common mistakes

  • Using brix as a fraction in the % form.
  • Applying water's specific heat to syrup.

Assumptions and limits

  • Cane products; empirical fits. The source gives no validity ranges for brix, temperature or purity; treat results near the ends of the input ranges with care.
  • The simple form is for juices: above about 30 brix use the Gucker and Ayres value (a note says so).

References

  • Hugot
  • Handbook of Cane Sugar Engineering
  • 3rd ed. (Elsevier, 1986)
  • ch. 30
  • eqns 30.1–30.2 (Gucker and Ayres)
  • p. 449

Questions and answers

How much lower than water?

About 10 % for mixed juice, 35–40 % for syrup.

Does purity matter?

A little: impurities lower the specific heat slightly more than sucrose.

Which form to use?

The simple form for juices; Gucker and Ayres for syrups and molasses or hot products.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.