Worked example
Example: 41 mm tubes, 30 per pass. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Juice flow | 260.00 t/h |
| Juice density | 1,060.0 kg/m³ |
| Juice viscosity | 6.0000e-04 Pa·s |
| Tube inside diameter | 41.000 mm |
| Tubes per pass | 30.000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Juice velocity in the tubes | 1.7202 m/s |
| Reynolds number | 124,602 |
Open this example in the calculator and change any input.
Formula
\(v = \frac{\dot m_j}{\rho\,n\,\pi d_i^2/4}, \quad Re = \frac{\rho v d_i}{\mu}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot m_j\) | Juice flow | kg/s |
| \(\rho\) | Juice density | kg/m³ |
| \(\mu\) | Juice viscosity | Pa·s |
| \(d_i\) | Tube inside diameter | m |
| \(n\) | Tubes per pass | - |
| \(v\) | Juice velocity in the tubes | m/s |
| \(Re\) | Reynolds number | - |
Method and standards
Continuity.
Where it is used
- Juice heater pass arrangement.
Common mistakes
- Counting all tubes instead of tubes per pass.
Assumptions and limits
- Full tubes.
- A note compares the velocity with the usual 1.5–2 m/s, the same band as the juice heater coefficient and pressure drop calculators.
References
- Continuity v = ṁ/(ρ n π d²/4); Re = ρ v d/μ
Questions and answers
Why does velocity matter?
Higher velocity raises the film coefficient and slows scale, at the cost of pressure drop.
How to raise it?
Fewer tubes per pass, so more passes for the same surface.
Viscosity of juice?
Close to water at heater temperatures; syrup is far more viscous.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.