FireCADCalc

Juice Clarifier Volume and Area

Clarifier working volume, settling area and diameter from the juice flow, the retention time and the working depth.

Sugar mill and cogeneration

Inputs

Examples: 250 m3/h, 2.5 hShort retention

Rapid (SRI) clarifiers about 20 min. Hugot ch. 29 sizes tray clarifiers by volume, 2.4–3.8 m³ per t cane/h, which is not a time: divide it by the juice volume per tonne cane to get hours.

Results

Short-retention clarifiers trade volume for lower sucrose inversion and colour; choose time and depth by design.

Working volume250.00m³
Plan area V/H71.429m²
Diameter of one round clarifier9.5365m

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 250 m3/h, 2.5 h. The inputs, in the units selected above:

InputValue
Juice flow250.00 m³/h
Retention time2.5000 h
Working depth5.0000 m

Applying the formula below gives:

ResultValue
Working volume625.00 m³
Plan area V/H125.00 m²
Diameter of one round clarifier12.616 m

Open this example in the calculator and change any input.

Formula

\(V = \dot V t, \quad A = \frac{V}{H}, \quad D = \sqrt{4A/\pi}\)

Variables

Symbol Meaning SI unit
\(\dot V\) Juice flow m³/s
\(t\) Retention time s
\(H\) Working depth m
\(V\) Working volume m³
\(A\) Plan area V/H (single compartment) m²
\(D\) Diameter of one round clarifier m

Method and standards

Definitions.

Where it is used

  • Clarifier sizing.
  • Capacity checks on expansion.

Common mistakes

  • Peak juice flow ignored.

Assumptions and limits

  • Plug flow.
  • The area here is the plan area of one compartment, V/H, and so depends on the depth chosen. Settling capacity depends on area, not depth (Hugot); check the area against the mud settling velocity with the clarifier settling area calculator. For a multi-tray clarifier the settling area is the sum of the trays.

References

  • V = Q t
  • A = V/H (definitions); retention and depth by design practice (Rein, Cane Sugar Engineering)

Questions and answers

Long or short retention?

Long retention gives margin but inverts sucrose; modern designs use short retention.

Area or volume?

Settling needs area; volume follows from depth.

Trays?

Multi-tray clarifiers add area for the same footprint: divide the area among trays.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.