FireCADCalc

Tensile Strength and Endurance Limit from Brinell Hardness

Approximate ultimate tensile strength of steel from Brinell hardness, and the unnotched rotating-bending endurance limit estimate from it.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationRefinery and petrochemicalChemical and fertiliserPulp and paper

Inputs

Examples: 200 HB normalised steelQuenched and tempered 450 HB

Results

S_u ≈ 3.45HB MPa for carbon and low-alloy steels (±10 %); not for cast iron, stainless steels or non-ferrous metals. The endurance limit estimate is for polished specimens; apply surface, size and reliability factors.

Estimated tensile strength690.00MPa
Estimated endurance limit345.00MPa

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 200 HB normalised steel. The inputs, in the units selected above:

InputValue
Brinell hardness200.00 -
Strength factor (MPa per HB)3.4500 -

Applying the formula below gives:

ResultValue
Estimated tensile strength690.00 MPa
Estimated endurance limit345.00 MPa

Open this example in the calculator and change any input.

Formula

\(S_u \approx 3.45\,HB\ \mathrm{MPa}, \quad S_e' = \min(0.5S_u, 700\ \mathrm{MPa})\)

Variables

Symbol Meaning SI unit
\(HB\) Brinell hardness -
\(k\) Strength factor (MPa per HB) -
\(S_u\) Estimated tensile strength Pa
\(S_e'\) Estimated endurance limit Pa

Method and standards

Empirical correlations.

Where it is used

  • Checking material in service by portable hardness.
  • Screening fatigue strength.

Common mistakes

  • Applying the rule to cast iron.
  • Using the endurance limit without surface factors.

Assumptions and limits

  • Steels (carbon and low-alloy). Above about 450 HB the relation is less reliable and is flagged.

References

  • S_u ≈ 3.45 HB MPa (steels; Shigley's Mechanical Engineering Design, ch. 2) and S_e' = 0.5S_u up to 700 MPa (ch. 6)

Questions and answers

How accurate is the hardness rule?

About ±10 % for plain carbon and low-alloy steels; check with a tensile test for design.

Why cap the endurance limit at 700 MPa?

Above about 1,400 MPa tensile strength, fatigue strength stops rising in proportion.

What do the defaults represent?

A normalised medium-carbon steel at 200 HB.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.