FireCADCalc

Lever Rule: Phase Fractions from a Phase Diagram

Mass fractions and masses of two phases in a two-phase field of a binary phase diagram from the alloy composition and the two tie-line end compositions.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationRefinery and petrochemicalChemical and fertiliserPulp and paper

Inputs

Examples: 0.40 % C steel below 727 °CPb–Sn 40 % Sn at 150 °C

Results

Read both tie-line ends at the same temperature from the diagram. For steels just below the eutectoid, α is ferrite (about 0.02 % C) and β is pearlite or cementite depending on the question.

Mass fraction of α49.333%
Mass fraction of β50.667%
Mass of α49.333kg
Mass of β50.667kg

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 0.40 % C steel below 727 °C. The inputs, in the units selected above:

InputValue
Overall alloy composition (wt %)0.40000 %
Composition of phase α, tie-line end (wt %)0.020000 %
Composition of phase β, tie-line end (wt %)0.77000 %
Alloy mass100.00 kg

Applying the formula below gives:

ResultValue
Mass fraction of α49.333 %
Mass fraction of β50.667 %
Mass of α49.333 kg
Mass of β50.667 kg

Open this example in the calculator and change any input.

Formula

\(W_\alpha = \frac{C_\beta - C_0}{C_\beta - C_\alpha}, \quad W_\beta = \frac{C_0 - C_\alpha}{C_\beta - C_\alpha}\)

Variables

Symbol Meaning SI unit
\(C_0\) Overall alloy composition -
\(C_\alpha\) Composition of phase α (tie-line end) -
\(C_\beta\) Composition of phase β (tie-line end) -
\(m\) Alloy mass kg
\(W_\alpha\) Mass fraction of α -
\(W_\beta\) Mass fraction of β -
\(m_\alpha\) Mass of α kg
\(m_\beta\) Mass of β kg

Method and standards

Mass balance.

Where it is used

  • Microstructure estimates for steels and alloys.
  • Teaching and exam problems.

Common mistakes

  • Reading tie-line ends at the wrong temperature.
  • Using atomic instead of weight per cent.

Assumptions and limits

  • Equilibrium; binary system.
  • Compositions in weight per cent give mass fractions of the phases; compositions in atomic per cent would give mole (atom) fractions instead.

References

  • Lever rule (mass balance along a tie line; Callister, Materials Science and Engineering, ch. 9)

Questions and answers

Why is it called the lever rule?

The phase fractions balance like weights on a lever with the fulcrum at the alloy composition.

What does the default show?

The fraction of proeutectoid ferrite and pearlite in a 0.40 % C steel just below 727 °C.

What do the defaults represent?

A 0.40 % carbon steel between ferrite (0.02 % C) and pearlite (0.77 % C).

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.