Worked example
Example: Mild steel constants, 20 µm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Friction stress | 70.000 MPa |
| Locking parameter (MPa·m^½) | 0.74000 - |
| Mean grain diameter | 20.000 µm |
| Target yield strength | 300.00 MPa |
Applying the formula below gives:
| Result | Value |
|---|---|
| Yield strength | 235.47 MPa |
| Grain size for the target | 10.352 µm |
Open this example in the calculator and change any input.
Formula
\(\sigma_y = \sigma_0 + \frac{k_y}{\sqrt d}, \quad d_t = \left(\frac{k_y}{\sigma_t - \sigma_0}\right)^2\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\sigma_0\) | Friction stress | Pa |
| \(k_y\) | Locking parameter (MPa·m^½) | - |
| \(d\) | Mean grain diameter | m |
| \(\sigma_t\) | Target yield strength | Pa |
| \(\sigma_y\) | Yield strength | Pa |
| \(d_t\) | Grain size for the target | m |
Method and standards
Hall–Petch.
Where it is used
- Steel selection and weld HAZ discussion.
- Teaching and examinations.
Common mistakes
- d in mm with k in MPa·m^½.
- Using one steel's constants for another.
Assumptions and limits
- Room temperature, single-phase.
- When the target is at or below σ₀ any grain size reaches it, and the grain size for the target is not shown.
References
- Hall (1951) and Petch (1953): σ_y = σ₀ + k_y d^(−½)
Questions and answers
Mild steel constants, 20 µm grains?
About 235 MPa.
Grain size for 300 MPa?
About 10.4 µm.
Why do fine grains strengthen?
Grain boundaries block dislocations.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.