Worked example
Example: Jaw crusher 1.2 m wide, 150 mm set. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Crusher | Jaw crusher |
| Inner width of the jaw crusher | 1.2000 m |
| Head mantle diameter at discharge (gyratory) | 1.5000 m |
| Open-side setting | 150.00 mm |
| Throw | 35.000 mm |
| Angle of nip | 20.000 ° |
| Speed | 220.00 rpm |
| Material constant (jaw 1.5–2, gyratory 2–3) | 1.7500 - |
| Bulk density of the product | 1.6000 g/cm³ |
| Gape (feed opening) | 0.90000 m |
Applying the formula below gives:
| Result | Value |
|---|---|
| Volumetric capacity | 399.84 m³/h |
| Mass capacity | 639.74 t/h |
| Taggart's limit (jaw below, gyratory above) | 130.98 t/h |
Open this example in the calculator and change any input.
Formula
\(Q_{jaw} = B S s\cot\alpha\, k\, 60n, \quad Q_{gyr} = (D - S)\pi S s\cot\alpha\, k\, 60n\ \ (\text{m}^3/\text{h})\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\text{type}\) | Crusher | - |
| \(B\) | Inner width of the jaw crusher | m |
| \(D\) | Head mantle diameter at discharge (gyratory) | m |
| \(S\) | Open-side setting | m |
| \(s\) | Throw | m |
| \(\alpha\) | Angle of nip | rad |
| \(n\) | Speed | 1/s |
| \(k\) | Material constant (jaw 1.5–2, gyratory 2–3) | - |
| \(\rho_b\) | Bulk density of the product | kg/m³ |
| \(G\) | Gape (feed opening) | m |
| \(Q\) | Volumetric capacity | m³/s |
| \(\dot m\) | Mass capacity | kg/s |
| \(161.7G^2\) | Taggart's limit (jaw below, gyratory above) | kg/s |
Method and standards
Broman's volumetric capacity model.
Where it is used
- Selecting primary crushers.
- Checking capacity after a setting change.
Common mistakes
- Using the closed-side setting.
- Ignoring the bulk density of broken rock.
Assumptions and limits
- Choke-fed crusher; dry, free-flowing feed.
References
- Wills and Finch
- Wills' Mineral Processing Technology
- 8th ed. (Butterworth-Heinemann, 2016)
- ch. 6
- eqs. 6.1-6.2 (Broman, 1984) and Taggart's rule (1945)
Questions and answers
What is the angle of nip?
The angle between the jaw (or mantle) and the fixed plate; too large and lumps squeeze upward instead of being gripped.
Why use the open-side setting?
The widest discharge gap sets the largest lumps passing and so the volume discharged per stroke.
What do the defaults represent?
A 1.2 m wide jaw crusher at 150 mm open-side setting, 35 mm throw, 20° nip, 220 rpm, k = 1.75, with a 0.9 m gape.
Method and article reviewed by FireCAD engineering on 17 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.