FireCADCalc

Crusher–Screen Circuit Circulating Load from Screen Efficiency

Circulating load of a closed crushing circuit from the screen efficiency and the undersize in the screen feed, with the oversize returned and the screen feed rate.

Inputs

Examples: Screen 85 % efficient, 50 % undersize in screen feedEfficient screen, coarse crusher productWorn screen deck

Results

Assumes no oversize passes through the screen (u = 1) and steady state. In a circuit with the crusher first, f is the undersize in the crusher product; with the screen first it is the undersize in the combined screen feed.

Circulating load (oversize / product)135.29%
Oversize returned to the crusher405.88t/h
Screen feed rate705.88t/h

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Screen 85 % efficient, 50 % undersize in screen feed. The inputs, in the units selected above:

InputValue
Screen efficiency (undersize recovered to the undersize product)85.000 %
Undersize (finer than the aperture) in the screen feed50.000 %
Fresh feed (= circuit product)300.00 t/h

Applying the formula below gives:

ResultValue
Circulating load (oversize / product)135.29 %
Oversize returned to the crusher405.88 t/h
Screen feed rate705.88 t/h

Open this example in the calculator and change any input.

Formula

\(C = \frac{O}{U} = \frac{1}{E_U f} - 1, \quad E_U = \frac{U}{F f}\)

Variables

Symbol Meaning SI unit
\(E_U\) Screen efficiency (undersize recovered to the undersize product) -
\(f\) Undersize (finer than the aperture) in the screen feed -
\(U\) Fresh feed (= circuit product) kg/s
\(C\) Circulating load (oversize / product) -
\(O\) Oversize returned to the crusher kg/s
\(F\) Screen feed rate kg/s

Method and standards

Mass balance on the screen undersize.

Where it is used

  • Sizing crushers and screens in closed circuit.
  • Diagnosing screen wear from rising circulating load.

Common mistakes

  • Using the fresh-feed size analysis for f.
  • Expressing circulating load against screen feed.

Assumptions and limits

  • No oversize in the undersize product.

References

  • Wills and Finch
  • Wills' Mineral Processing Technology
  • 8th ed. (Butterworth-Heinemann, 2016)
  • ch. 8
  • eqs. 8.1-8.10

Questions and answers

Why does a worn screen raise the circulating load?

Lower efficiency leaves more fines in the oversize, which go back to the crusher, take up capacity and are crushed again.

How is screen efficiency found?

From sieve analyses of feed, oversize and undersize with the two-product formula on the fraction finer than the aperture (the screen efficiency calculator).

What do the defaults represent?

A screen 85 % efficient with half its feed finer than the aperture, closing a crusher on 300 t/h of fresh feed.

Method and article reviewed by FireCAD engineering on 17 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.