Worked example
Example: Screen 85 % efficient, 50 % undersize in screen feed. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Screen efficiency (undersize recovered to the undersize product) | 85.000 % |
| Undersize (finer than the aperture) in the screen feed | 50.000 % |
| Fresh feed (= circuit product) | 300.00 t/h |
Applying the formula below gives:
| Result | Value |
|---|---|
| Circulating load (oversize / product) | 135.29 % |
| Oversize returned to the crusher | 405.88 t/h |
| Screen feed rate | 705.88 t/h |
Open this example in the calculator and change any input.
Formula
\(C = \frac{O}{U} = \frac{1}{E_U f} - 1, \quad E_U = \frac{U}{F f}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(E_U\) | Screen efficiency (undersize recovered to the undersize product) | - |
| \(f\) | Undersize (finer than the aperture) in the screen feed | - |
| \(U\) | Fresh feed (= circuit product) | kg/s |
| \(C\) | Circulating load (oversize / product) | - |
| \(O\) | Oversize returned to the crusher | kg/s |
| \(F\) | Screen feed rate | kg/s |
Method and standards
Mass balance on the screen undersize.
Where it is used
- Sizing crushers and screens in closed circuit.
- Diagnosing screen wear from rising circulating load.
Common mistakes
- Using the fresh-feed size analysis for f.
- Expressing circulating load against screen feed.
Assumptions and limits
- No oversize in the undersize product.
References
- Wills and Finch
- Wills' Mineral Processing Technology
- 8th ed. (Butterworth-Heinemann, 2016)
- ch. 8
- eqs. 8.1-8.10
Questions and answers
Why does a worn screen raise the circulating load?
Lower efficiency leaves more fines in the oversize, which go back to the crusher, take up capacity and are crushed again.
How is screen efficiency found?
From sieve analyses of feed, oversize and undersize with the two-product formula on the fraction finer than the aperture (the screen efficiency calculator).
What do the defaults represent?
A screen 85 % efficient with half its feed finer than the aperture, closing a crusher on 300 t/h of fresh feed.
Method and article reviewed by FireCAD engineering on 17 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.