FireCADCalc

Steam from Biogas in a Boiler

Heat input and steam raised by burning biogas in a boiler from its flow, methane content, heating value and boiler efficiency, with IF97 enthalpies.

Distillery and ethanolIAPWS-IF97 (water and steam)Boiler

Inputs

Examples: 1500 Nm3/h at 58 %Small boiler

Results

H₂S in biogas forms SO₂ and acid dew point problems: scrub it before the boiler.

Heat input2.4662MW
Heat per kg of steam (dry saturated)2,432.8kJ/kg
Steam3.1021t/h

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 1500 Nm3/h at 58 %. The inputs, in the units selected above:

InputValue
Biogas1,500.0 Nm³/h
Methane in biogas58.000 %
Methane net heating value35.800 MJ/Nm³
Boiler efficiency (net basis)88.000 %
Steam pressure (absolute)11.000 bar
Feedwater temperature105.00 °C

Applying the formula below gives:

ResultValue
Heat input8.6517 MW
Heat per kg of steam (dry saturated)2,339.7 kJ/kg
Steam11.714 t/h

Open this example in the calculator and change any input.

Formula

\(\dot Q = \dot V_b y_{CH_4} LHV, \quad \dot m_s = \frac{\eta_b \dot Q}{h_g(p) - h(p, T_{fw})}\)

Variables

Symbol Meaning SI unit
\(\dot V_b\) Biogas Nm³/s
\(y_{CH_4}\) Methane in biogas -
\(LHV\) Methane net heating value J/m³
\(\eta_b\) Boiler efficiency (net basis) -
\(p\) Steam pressure (absolute) Pa
\(T_{fw}\) Feedwater temperature K
\(\dot Q\) Heat input W
\(\Delta h\) Heat per kg of steam (dry saturated) J/kg
\(\dot m_s\) Steam kg/s

Method and standards

Energy balance.

Where it is used

  • Biogas utilisation in distillery boilers.
  • Fuel saving reports.

Common mistakes

  • Gross efficiency with net heating value.

Assumptions and limits

  • Dry saturated steam.

References

  • Energy balance with IAPWS-IF97 enthalpies; methane LHV 35.8 MJ/Nm³ from 802.3 kJ/mol (NIST) by default

Questions and answers

Steam per Nm³ of biogas?

Roughly 7–8.5 kg of low-pressure steam at about 60 % methane.

Why net basis?

Biogas heating values are usually stated net; use the efficiency on the same basis.

Superheated steam?

Add the superheat enthalpy; this calculator takes dry saturated steam.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.