Worked example
Example: 1000 mg/L on 250 m3/h. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Juice flow | 250.00 m³/h |
| SO₂ dose on juice | 1,000.0 mg/L |
| Crushing rate | 250.00 t/h |
Applying the formula below gives:
| Result | Value |
|---|---|
| SO₂ needed | 250.00 kg/h |
| Sulphur burnt (theoretical, complete burning) | 125.12 kg/h |
| Sulphur per tonne cane | 0.50048 kg/t |
Open this example in the calculator and change any input.
Formula
\(\dot m_{SO_2} = \dot V_j\,c, \quad \dot m_S = \dot m_{SO_2}\frac{M_S}{M_S + 2 M_O}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot V_j\) | Juice flow | m³/s |
| \(c\) | SO₂ dose on juice | kg/m³ |
| \(C\) | Crushing rate | kg/s |
| \(\dot m_{SO_2}\) | SO₂ needed | kg/s |
| \(\dot m_S\) | Sulphur burnt (theoretical, complete burning) | kg/s |
| \(s\) | Sulphur per tonne cane | kg/kg |
Method and standards
Stoichiometry.
Where it is used
- Sulphitation plant sizing.
- Chemical consumption reports.
Common mistakes
- Dose in ppm by mass on a volume basis.
Assumptions and limits
- Complete combustion: the sulphur is the theoretical minimum; sublimed or unburnt sulphur raises the real use.
- Juice flow and crushing rate are separate inputs; they are not checked against each other (juice % cane).
References
- Stoichiometry S + O₂ → SO₂ with IUPAC atomic masses
Questions and answers
How much SO₂ per kg of sulphur?
About 2 kg: the molar masses are 64 and 32.
Why is actual sulphur higher?
Sublimation and incomplete burning in the burner.
Where is SO₂ dosed?
In double sulphitation, to raw juice and again to syrup.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.