FireCADCalc

Mud Filter Area from Cake and Filtration Rate

Filter cake made per hour from the crush and cake % cane, and the rotary vacuum or belt filter area from the filtration rate.

Sugar mill and cogenerationDistillery and ethanol

Inputs

Examples: 250 TCH, 3.5 % cakeBelt filter

Hugot ch. 31: 3–4 kg cake per 100 kg cane at 75–80 % moisture.
Hugot ch. 31: 60–75 kg/(m²·h); 0.3–0.8 m² of filter per t cane/h in practice.

Results

0.33 m² per t cane/h, within the 0.3–0.8 of practice.

Filter cake made4.5000t/h
Filter area50.000m²

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 250 TCH, 3.5 % cake. The inputs, in the units selected above:

InputValue
Crushing rate250.00 t/h
Filter cake % cane3.5000 %
Filtration rate (cake per filter area)60.000 kg/(m²·h)

Applying the formula below gives:

ResultValue
Filter cake made8.7500 t/h
Filter area145.83 m²

Open this example in the calculator and change any input.

Formula

\(\dot m_{FC} = C\,FC, \quad A = \frac{\dot m_{FC}}{r}\)

Variables

Symbol Meaning SI unit
\(C\) Crushing rate kg/s
\(FC\) Filter cake % cane -
\(r\) Filtration rate (cake per filter area) kg/(m²·s)
\(\dot m_{FC}\) Filter cake made kg/s
\(A\) Filter area m²

Method and standards

Mass balance.

Where it is used

  • Filter station sizing.
  • Press mud for composting.

Common mistakes

  • Mixing wet and dry cake rates.

Assumptions and limits

  • Wet cake basis.
  • The area per t cane/h is compared with the 0.3–0.8 m² of practice quoted by Hugot.

References

  • Mass balance; cake % cane and filtration rate from Hugot
  • Handbook of Cane Sugar Engineering
  • 3rd ed. (Elsevier, 1986)
  • ch. 31
  • Oliver filters
  • pp. 473–483

Questions and answers

What is press mud used for?

Compost, often with distillery spent wash.

Why size on cake?

The filter's rating is the cake it discharges per square metre.

Pol loss?

Cake pol % cane is a determined loss in the pol balance.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.