Worked example
Example: 2 kN·m, 2 m, 60 mm solid steel. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Torque | 2,000.0 N·m |
| Shaft length | 2.0000 m |
| Outside diameter | 60.000 mm |
| Inside diameter (0 for a solid shaft) | 0 mm |
| Shear modulus of the material | 80.000 GPa |
Applying the formula below gives:
| Result | Value |
|---|---|
| Polar moment of area π(D⁴ − d⁴)/32 | 127.23 cm⁴ |
| Angle of twist T L / (G J) | 2.2516 ° |
| Maximum shear stress T (D/2) / J | 47.157 MPa |
| Torsional stiffness G J / L (torque per radian) | 50,894 N·m |
| Twist per metre of length (per m in every unit system) | 1.1258 ° |
Open this example in the calculator and change any input.
Formula
\(J = \frac{\pi (D^4 - d^4)}{32}, \quad \theta = \frac{T L}{G J}, \quad \tau_{max} = \frac{T\, D/2}{J}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(T\) | Torque | N·m |
| \(L\) | Shaft length | m |
| \(D\) | Outside diameter | m |
| \(d\) | Inside diameter (0 for a solid shaft) | m |
| \(G\) | Shear modulus of the material | Pa |
| \(J\) | Polar moment of area π(D⁴ − d⁴)/32 | m⁴ |
| \(\theta\) | Angle of twist T L / (G J) | rad |
| \(\tau_{max}\) | Maximum shear stress T (D/2) / J | Pa |
| \(k_t\) | Torsional stiffness G J / L (torque per radian) | N·m |
| \(\theta/L\) | Twist per metre of length | rad/m |
Method and standards
Torsion equation for straight circular shafts.
Where it is used
- Line shafts and long drives.
- Coupling alignment.
- Strength of materials examinations.
Common mistakes
- Using I instead of J.
- Degrees and radians mixed.
Assumptions and limits
- Elastic, circular, uniform shaft.
- The twist per length is always given per metre, also when lengths are shown in feet (multiply by 0.3048 for per foot).
References
- Elastic torsion of circular shafts (T/J = τ/r = Gθ/L)
Questions and answers
How much does a 60 mm steel shaft twist under 2 kN·m over 2 m?
0.0393 rad = 2.25°, with a maximum shear stress of 47.2 MPa.
Why are hollow shafts used?
Most torque is carried near the surface; a 120/80 mm tube has 80 % of the solid stiffness at 56 % of the weight.
What shear modulus for steel?
About 80 GPa; use your material's value.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.