Worked example
Example: 400 mm radius steel disc, 3 000 rpm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Outer radius | 400.00 mm |
| Speed | 3,000.0 rpm |
| Density | 7,850.0 kg/m³ |
| Poisson's ratio | 0.30000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Rim speed | 125.66 m/s |
| Hoop stress in a thin ring ρ v² | 123.96 MPa |
| Maximum stress in a solid disc (centre) | 51.134 MPa |
| Hoop stress at the rim of the solid disc | 21.693 MPa |
Open this example in the calculator and change any input.
Formula
\(\sigma_{ring} = \rho v^2, \quad \sigma_{max} = \frac{3 + \nu}{8}\rho\omega^2 r_o^2, \quad \sigma_{t,rim} = \frac{1 - \nu}{4}\rho\omega^2 r_o^2\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(r_o\) | Outer radius | m |
| \(N\) | Speed | 1/s |
| \(\rho\) | Density | kg/m³ |
| \(\nu\) | Poisson's ratio | - |
| \(v\) | Rim speed | m/s |
| \(\sigma_{ring}\) | Hoop stress in a thin ring ρ v² | Pa |
| \(\sigma_{max}\) | Maximum stress in a solid disc (centre) | Pa |
| \(\sigma_{t,rim}\) | Hoop stress at the rim of the solid disc | Pa |
Method and standards
Elastic solution for a rotating disc.
Where it is used
- Flywheels, fans and grinding wheels.
- Strength of materials examinations.
Common mistakes
- Diameter for radius.
- Ignoring a bore.
Assumptions and limits
- Solid disc, uniform thickness. A disc with a central bore is not covered: even a small hole about doubles the hoop stress at the bore compared with the solid-disc centre value.
- Stresses are not compared with an allowable stress or a burst speed; check them against the material's strength with your design margin.
References
- Shigley's Mechanical Engineering Design (Budynas and Nisbett)
- ch. 3 (rotating rings and discs, (3 + ν)/8 ρ ω² r²)
Questions and answers
A 400 mm radius steel disc at 3000 rpm?
Rim speed 126 m/s; centre stress 51.1 MPa.
Why does a thin ring see more?
It has no inner material to share the load: σ = ρ v².
What limits flywheels?
Rim speed, since stress depends only on ρ v².
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.