Worked example
Example: 1.2 kN·m and 1.6 kN·m on 60 mm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Bending moment | 1,200.0 N·m |
| Twisting moment (torque) | 1,600.0 N·m |
| Shaft diameter | 60.000 mm |
| Allowable shear stress (to size the shaft) | 50.000 MPa |
Applying the formula below gives:
| Result | Value |
|---|---|
| Equivalent twisting moment √(M² + T²) | 2,000.0 N·m |
| Equivalent bending moment (M + T_e)/2 | 1,600.0 N·m |
| Maximum shear stress 16 T_e/(π d³) | 47.157 MPa |
| Maximum normal stress 32 M_e/(π d³) | 75.451 MPa |
| Diameter for the allowable shear stress | 58.841 mm |
Open this example in the calculator and change any input.
Formula
\(T_e = \sqrt{M^2 + T^2}, \quad M_e = \tfrac12 (M + T_e), \quad \tau_{max} = \frac{16 T_e}{\pi d^3}, \quad \sigma_{max} = \frac{32 M_e}{\pi d^3}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(M\) | Bending moment | N·m |
| \(T\) | Twisting moment (torque) | N·m |
| \(d\) | Shaft diameter | m |
| \(\tau_a\) | Allowable shear stress (to size the shaft) | Pa |
| \(T_e\) | Equivalent twisting moment √(M² + T²) | N·m |
| \(M_e\) | Equivalent bending moment (M + T_e)/2 | N·m |
| \(\tau_{max}\) | Maximum shear stress 16 T_e/(π d³) | Pa |
| \(\sigma_{max}\) | Maximum normal stress 32 M_e/(π d³) | Pa |
| \(d_{min}\) | Diameter for the allowable shear stress | m |
Method and standards
Principal stresses at the shaft surface.
Where it is used
- Line shafts and spindles.
- Machine design examinations.
Common mistakes
- Adding M and T directly.
- Forgetting shock factors.
Assumptions and limits
- Solid round shaft, static. Shock and fatigue factors (K_m, K_t), keyways and other stress raisers are not applied: multiply M and T by your factors before entering them.
- d_min sizes the shaft by the maximum shear stress (Guest) only; check σ_max against the allowable normal stress (Rankine) as well.
References
- Textbook mechanics (Guest's maximum shear stress and Rankine's maximum normal stress theories)
Questions and answers
1.2 kN·m bending and 1.6 kN·m torque on a 60 mm shaft?
T_e = 2 kN·m: shear 47.2 MPa; normal 75.5 MPa.
What diameter for 50 MPa shear?
58.8 mm.
Which theory for ductile shafts?
Maximum shear (Guest) or distortion energy; Rankine suits brittle materials.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.