Worked example
Example: 10 kN/m over 4 m. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Loading | Uniform load w over the span |
| Central point load | 0 kN |
| Uniform load per metre | 10.000 kN/m |
| Span | 4.0000 m |
| Young's modulus | 200.00 GPa |
| Second moment of area | 836.00 cm⁴ |
Applying the formula below gives:
| Result | Value |
|---|---|
| Moment at the fixed ends (hogging) | 13,333 N·m |
| Moment at mid-span (sagging) | 6,666.7 N·m |
| Reaction at each end | 20.000 kN |
| Deflection at mid-span | 3.9872 mm |
Open this example in the calculator and change any input.
Formula
\(\text{UDL: } M_e = \frac{wL^2}{12},\ M_c = \frac{wL^2}{24},\ \delta = \frac{wL^4}{384EI}; \quad \text{point: } M_e = M_c = \frac{WL}{8},\ \delta = \frac{WL^3}{192EI}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\text{load}\) | Loading | - |
| \(W\) | Central point load | N |
| \(w\) | Uniform load per metre | N/m |
| \(L\) | Span | m |
| \(E\) | Young's modulus | Pa |
| \(I\) | Second moment of area | m⁴ |
| \(M_e\) | Moment at the fixed ends (hogging) | N·m |
| \(M_c\) | Moment at mid-span (sagging) | N·m |
| \(R\) | Reaction at each end | N |
| \(\delta_{max}\) | Deflection at mid-span | m |
Method and standards
Elastic beam theory.
Where it is used
- Continuous frames and built-in beams.
- Strength of materials examinations.
Common mistakes
- Assuming full fixity.
- Mixing load per metre and total load.
Assumptions and limits
- Prismatic beam, small deflections.
- The point load W is used for the central-load case and the load per metre w for the uniform case, each in its own unit.
- Stresses are not computed (no section modulus input): σ = M/Z with the larger of M_e and M_c. Support rotation, which relieves the end moments, is not modelled.
References
- Textbook mechanics (standard beam formulas, Roark's Formulas for Stress and Strain)
Questions and answers
10 kN/m over a 4 m fixed beam?
End moments 13.3 kN·m, mid-span 6.7 kN·m, reactions 20 kN.
How does it compare with simply supported?
Deflection is a fifth, and the largest moment two thirds.
Central point load?
WL/8 at the ends and at mid-span; deflection WL³/(192EI).
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.