Worked example
Example: 1e-4 1/s at 25 °C, 50 kJ/mol, to 35 °C. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Rate constant at T₁ (first order) | 1.0000e-04 1/s |
| Temperature at which k₁ was measured | 25.000 °C |
| Activation energy | 50.000 kJ/mol |
| New temperature | 35.000 °C |
Applying the formula below gives:
| Result | Value |
|---|---|
| Rate constant at T₂ | 1.9243e-04 1/s |
| Rate ratio | 1.9243 |
| Pre-exponential factor | 57,494 1/s |
| Half-life at T₂ (first order) | 60.036 min |
Open this example in the calculator and change any input.
Formula
\(k_2 = k_1 \exp\left[-\frac{E_a}{R}\left(\frac{1}{T_2} - \frac{1}{T_1}\right)\right]\)
\(A = k_1 e^{E_a/(R T_1)}, \quad t_{1/2} = \frac{\ln 2}{k_2}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(k_1\) | Rate constant at T₁ (first order) | 1/s |
| \(T_1\) | Temperature at which k₁ was measured | K |
| \(E_a\) | Activation energy | J/mol |
| \(T_2\) | New temperature | K |
| \(k_2\) | Rate constant at T₂ | 1/s |
| \(k_2 / k_1\) | Rate ratio | - |
| \(A\) | Pre-exponential factor | 1/s |
| \(t_{1/2}\) | Half-life at T₂ (first order) | s |
| \(R\) | Universal gas constant | J/(mol·K) |
Method and standards
The Arrhenius relation between rate constant and absolute temperature with the CODATA gas constant.
Where it is used
- Scaling reaction times between temperatures.
- Shelf-life and accelerated ageing estimates.
- Corrosion and degradation rates.
Common mistakes
- Using °C instead of K.
- Using J/mol and kJ/mol mixed.
- Extrapolating far outside the measured range.
Assumptions and limits
- Constant activation energy over the range.
- The half-life ln 2/k₂ applies to a first-order reaction only; for other orders ignore it.
- At extreme activation energies and low temperatures the pre-exponential factor overflows and is not shown.
References
- S. Arrhenius (1889); CODATA gas constant
Questions and answers
How much faster is a 50 kJ/mol reaction at 35 °C than at 25 °C?
1.92 times: the old rule of a doubling per 10 K holds near room temperature for about 50 kJ/mol.
What is the half-life?
For a first-order reaction ln 2/k: 3 600 s (1 hour) at 35 °C in that example.
Can I use it for other orders?
Yes for k, in your own units; the half-life shown is for first order only.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.