FireCADCalc

Adiabatic Temperature Rise of a Reactor

Adiabatic temperature rise of a liquid-phase reaction from heat of reaction, feed concentration, conversion, density and specific heat, with the outlet temperature.

Refinery and petrochemicalChemical and fertiliser

Inputs

Examples: Exothermic liquid reactionDilute, endothermic

Results

A large adiabatic rise means a cooling failure could run away: check it against the decomposition temperature.

Screening energy balance only (no heat of mixing, vaporisation or decomposition): not a basis for relief sizing.

Adiabatic temperature rise63.158K
Outlet temperature (adiabatic)113.16°C
Rise at full conversion70.175K

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Exothermic liquid reaction. The inputs, in the units selected above:

InputValue
Heat of reaction (negative: exothermic)-80.000 kJ/mol
Feed concentration of the key reactant2.0000 mol/L
Conversion90.000 %
Mixture density950.00 kg/m³
Mixture specific heat2.4000 kJ/(kg·K)
Feed temperature50.000 °C

Applying the formula below gives:

ResultValue
Adiabatic temperature rise63.158 K
Outlet temperature (adiabatic)113.16 °C
Rise at full conversion70.175 K

Open this example in the calculator and change any input.

Formula

\(\Delta T_{ad} = \frac{(-\Delta H_r) C_{A0} X}{\rho c_p}\)

Variables

Symbol Meaning SI unit
\(\Delta H_r\) Heat of reaction (negative: exothermic) J/mol
\(C_{A0}\) Feed concentration of the key reactant mol/m³
\(X\) Conversion -
\(\rho\) Mixture density kg/m³
\(c_p\) Mixture specific heat J/(kg·K)
\(T_0\) Feed temperature K
\(\Delta T_{ad}\) Adiabatic temperature rise K
\(T\) Outlet temperature (adiabatic) K
\(\Delta T_{ad,100}\) Rise at full conversion K

Method and standards

Energy balance.

Where it is used

  • Reactor safety studies.
  • Batch reactor design.

Common mistakes

  • Concentration in mol/L used as mol/m³.
  • Sign of ΔH.

Assumptions and limits

  • Constant properties, no heat loss.
  • Screening energy balance: no heat of mixing, no vaporisation or vapour pressure, no decomposition onset. Not a design basis for relief sizing (use calorimetry data and a recognised relief method).
  • An endothermic reaction (ΔH_r > 0) gives a fall; a fall that would take the mixture below 0 K is rejected.

References

  • Energy balance ΔT_ad = (−ΔH_r) C_A0 X/(ρ c_p) (Fogler; Stoessel, Thermal Safety of Chemical Processes)

Questions and answers

−80 kJ/mol at 2 mol/L, 90 % conversion?

About 63 K rise; 70 K at full conversion.

Why does it matter?

It is how hot the batch gets if cooling fails.

Gas-phase reactions?

Use the molar heat capacity of the gas mixture instead.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.