Worked example
Example: First order, 80 %. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Feed volumetric flow | 10.000 m³/h |
| Target conversion | 80.000 % |
| Reaction order | First order |
| Rate constant k·C_A0^(n−1) | 0.20000 1/min |
Applying the formula below gives:
| Result | Value |
|---|---|
| Residence time | 20.000 min |
| Reactor volume | 3.3333 m³ |
| Damköhler number k'τ | 4.0000 |
Open this example in the calculator and change any input.
Formula
\(\tau = \frac{X}{k(1 - X)} \ (n = 1), \quad \tau = \frac{X}{k C_{A0}(1 - X)^2} \ (n = 2), \quad V = \dot V \tau\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot V\) | Feed volumetric flow | m³/s |
| \(X\) | Target conversion | - |
| \(n\) | Reaction order | - |
| \(k'\) | Rate constant k·C_A0^(n−1) | 1/s |
| \(\tau\) | Residence time | s |
| \(V\) | Reactor volume | m³ |
| \(Da\) | Damköhler number k'τ | - |
Method and standards
CSTR design equation.
Where it is used
- Continuous reactors and neutralisers.
- Effluent treatment tanks.
Common mistakes
- Using inlet concentration for the rate.
- Volume without headspace.
Assumptions and limits
- Isothermal, constant density.
References
- CSTR design equation V = F_A0 X/(−r_A) at outlet conditions (Fogler; Levenspiel)
Questions and answers
10 m³/h, 80 %, first order k 0.2 /min?
τ = 20 min: 3.33 m³.
Why bigger than a PFR?
All the tank runs at the low outlet concentration.
Several tanks?
See CSTRs in series: they approach plug flow.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.