Worked example
Example: 1 m³ air at 500 psia. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Gas volume in the vessel | 1.0000 m³ |
| Burst pressure (absolute) | 3,447.4 kPa |
| Ambient pressure | 101.33 kPa |
| Heat capacity ratio of the gas | 1.4000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Brode's equation | 8,365.1 kJ |
| Isentropic expansion | 5,472.3 kJ |
| Isothermal expansion | 12,159 kJ |
| Thermodynamic availability | 8,813.0 kJ |
| TNT equivalent of Brode's energy | 1.7851 kg |
Open this example in the calculator and change any input.
Formula
\(E_{Brode} = \frac{(P_2 - P_1)V}{\gamma - 1}, \quad E_{isentropic} = \frac{P_2V}{\gamma - 1}\left[1 - \left(\frac{P_1}{P_2}\right)^{(\gamma - 1)/\gamma}\right]\)
\(E_{isothermal} = P_2V\ln\frac{P_2}{P_1}, \quad E_{avail} = P_2V\left[\ln\frac{P_2}{P_1} - \left(1 - \frac{P_1}{P_2}\right)\right]\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(V\) | Gas volume in the vessel | m³ |
| \(P_2\) | Burst pressure (absolute) | Pa |
| \(P_1\) | Ambient pressure | Pa |
| \(\gamma\) | Heat capacity ratio of the gas | - |
| \(E_{Brode}\) | Brode's equation | J |
| \(E_{isentropic}\) | Isentropic expansion | J |
| \(E_{isothermal}\) | Isothermal expansion | J |
| \(E_{avail}\) | Thermodynamic availability | J |
| \(m_{TNT}\) | TNT equivalent of Brode's energy | kg |
Method and standards
Energy of explosion for a compressed ideal gas by the four methods given by Crowl and Louvar; TNT equivalent at 4,686 kJ/kg.
Where it is used
- Pneumatic test safety distances (screening).
- Gas receivers and accumulators.
Common mistakes
- Using gauge pressure.
- Forgetting the gas volume excludes internals.
Assumptions and limits
- Ideal gas; ambient temperature.
References
- Crowl and Louvar
- Chemical Process Safety: Fundamentals with Applications
- 2nd ed. (Prentice Hall, 2002)
- ch. 6
- eqs. 6-28 to 6-31 (Brode; Crowl, thermodynamic availability)
Questions and answers
Why are hydrotests preferred to pneumatic tests?
Water is nearly incompressible and stores very little energy; the same vessel full of gas at test pressure stores thousands of times more.
Which method should I use?
All four are in use: isothermal gives the largest value and isentropic the smallest; Brode is common for near-field effects.
What do the defaults represent?
A 1 m³ vessel of air bursting at 500 psia into 1 atm.
Method and article reviewed by FireCAD engineering on 17 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.