FireCADCalc

Gas Pipes in Series: Equivalent Length

Equivalent length of up to three gas pipe segments of different bore in series, expressed in the bore of the first, for the same flow and transmission factor.

Thermal power plantProcess steam and utilitiesRefinery and petrochemicalChemical and fertiliserFuel oil and gas system

Inputs

Examples: NPS 16, 14 and 12 in seriesTwo segments

Results

Valid when the same flow passes through every segment (no deliveries between them) and the transmission factor is the same; use the total in the flow equation with diameter D₁.

Equivalent length of segment 233.870km
Equivalent length of segment 30km
Total equivalent length in diameter D₁43.870km

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: NPS 16, 14 and 12 in series. The inputs, in the units selected above:

InputValue
Length of segment 116.000 km
Inside diameter of segment 1393.70 mm
Length of segment 224.000 km
Inside diameter of segment 2342.90 mm
Length of segment 3 (0 = none)16.000 km
Inside diameter of segment 3292.10 mm

Applying the formula below gives:

ResultValue
Equivalent length of segment 247.885 km
Equivalent length of segment 371.169 km
Total equivalent length in diameter D₁135.05 km

Open this example in the calculator and change any input.

Formula

\(L_e = L_1 + L_2\left(\frac{D_1}{D_2}\right)^5 + L_3\left(\frac{D_1}{D_3}\right)^5\)

Variables

Symbol Meaning SI unit
\(L_1\) Length of segment 1 m
\(D_1\) Inside diameter of segment 1 m
\(L_2\) Length of segment 2 m
\(D_2\) Inside diameter of segment 2 m
\(L_3\) Length of segment 3 (0 = none) m
\(D_3\) Inside diameter of segment 3 m
\(L_{e2}\) Equivalent length of segment 2 m
\(L_{e3}\) Equivalent length of segment 3 m
\(L_e\) Total equivalent length in diameter D₁ m

Method and standards

Equivalent length from the general flow equation.

Where it is used

  • Lines with wall-thickness or diameter changes.
  • Adding a smaller lateral to a model.

Common mistakes

  • Applying it where the flow changes along the line.

Assumptions and limits

  • Same flow and transmission factor in every segment.

References

  • Menon
  • Gas Pipeline Hydraulics (CRC Press, 2005)
  • ch. 3.6
  • eqs. 3.1–3.6

Questions and answers

Why the fifth power of diameter?

In the general flow equation P₁² − P₂² is proportional to L/D⁵ at a fixed flow and transmission factor.

Can I use it with deliveries between segments?

No; with different flows in each segment, work segment by segment.

What do the defaults represent?

Three segments: 16 km of 393.7 mm, 24 km of 342.9 mm and 16 km of 292.1 mm bore (NPS 16, 14 and 12).

Method and article reviewed by FireCAD engineering on 17 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.