FireCADCalc

Vogel Inflow Performance for a Solution-Gas Drive Well

Maximum oil rate (AOF) of a well from one test point by Vogel's inflow relation, and the oil rate at any other bottom-hole flowing pressure.

Process steam and utilitiesRefinery and petrochemicalChemical and fertiliser

Inputs

Examples: 100 bbl/d test at 1,800 of 2,400 psiaWeak well near p_rRate at zero p_wf

Results

Vogel's relation is for saturated (solution-gas drive) reservoirs at or below the bubble point and assumes no skin. The productivity output is in SI (m³/s per Pa).

Maximum rate (absolute open flow)250.00bbl/d
Oil rate at p_wf211.11bbl/d
Productivity at p_wf (rate per drawdown)3.5214e-11

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 100 bbl/d test at 1,800 of 2,400 psia. The inputs, in the units selected above:

InputValue
Average reservoir pressure2,400.0 psi
Bottom-hole pressure on test1,800.0 psi
Oil rate on test100.00 bbl/d
Bottom-hole pressure of interest800.00 psi

Applying the formula below gives:

ResultValue
Maximum rate (absolute open flow)250.00 bbl/d
Oil rate at p_wf211.11 bbl/d
Productivity at p_wf (rate per drawdown)3.5214e-11

Open this example in the calculator and change any input.

Formula

\(\frac{q_o}{q_{max}} = 1 - 0.2\frac{p_{wf}}{\bar p_r} - 0.8\left(\frac{p_{wf}}{\bar p_r}\right)^2\)

Variables

Symbol Meaning SI unit
\(\bar p_r\) Average reservoir pressure Pa
\(p_{wf,t}\) Bottom-hole pressure on test Pa
\(q_t\) Oil rate on test m³/s
\(p_{wf}\) Bottom-hole pressure of interest Pa
\(q_{max}\) Maximum rate (absolute open flow) m³/s
\(q_o\) Oil rate at p_wf m³/s
\(J^*\) Productivity at p_wf (rate per drawdown) -

Method and standards

Vogel's dimensionless IPR.

Where it is used

  • Artificial lift and choke sizing.
  • Production forecasting.

Common mistakes

  • Using it above the bubble point.
  • Using a test at a different reservoir pressure.

Assumptions and limits

  • Saturated reservoir; zero skin.

References

  • Ahmed
  • Reservoir Engineering Handbook
  • 5th ed. (Gulf Professional Publishing, 2019)
  • ch. 7
  • eq. 7-9 (Vogel, 1968)

Questions and answers

Why is the IPR curved?

As bottom-hole pressure falls below the bubble point, gas comes out of solution and reduces the oil's mobility near the well.

What is AOF?

Absolute open flow: the theoretical rate at zero bottom-hole pressure, a measure of well capacity.

What do the defaults represent?

A well tested at 100 bbl/d with 1,800 psia flowing pressure in a 2,400 psia reservoir; rate at 800 psia.

Method and article reviewed by FireCAD engineering on 17 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.