FireCADCalc

UHT Direct Steam Injection: Steam and Added Water

Culinary steam to heat a product by direct injection from preheat to UHT temperature (IF97), the water it adds, and the flash in the vacuum cooler that removes it.

Food, dairy and textileIAPWS-IF97 (water and steam)Boiler

Inputs

Examples: 80 → 145 °C with 10 bar steamInfusion 75 → 140 °C

Results

Flashing back to the preheat temperature in the vacuum vessel removes the same water that the steam added.

Steam injected1,170.1kg/h
Water added (share of product)11.701%
Flash vessel temperature that removes the added water (equals the preheat temperature)80.000°C

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 80 → 145 °C with 10 bar steam. The inputs, in the units selected above:

InputValue
Product flow10,000 kg/h
Product specific heat3.9000 kJ/(kg·K)
Preheat temperature80.000 °C
UHT temperature145.00 °C
Steam pressure (absolute)10.000 bar

Applying the formula below gives:

ResultValue
Steam injected1,170.1 kg/h
Water added (share of product)11.701 %
Flash vessel temperature that removes the added water (equals the preheat temperature)80.000 °C

Open this example in the calculator and change any input.

Formula

\(\dot m_s = \frac{\dot M c_p (T_2 - T_1)}{h_g(p_s) - h_f(T_2)}\)

Variables

Symbol Meaning SI unit
\(\dot M\) Product flow kg/s
\(c_p\) Product specific heat J/(kg·K)
\(T_1\) Preheat temperature K
\(T_2\) UHT temperature K
\(p_s\) Steam pressure (absolute) Pa
\(\dot m_s\) Steam injected kg/s
\(\Delta w\) Water added (share of product) -
\(T_f\) Flash vessel temperature that removes the added water (equals the preheat temperature) K

Method and standards

Direct-contact heat balance with IF97.

Where it is used

  • UHT plant design.
  • Steam budgets.

Common mistakes

  • Ignoring that injected steam dilutes the product.
  • Using indirect heating figures.

Assumptions and limits

  • Complete condensation; no losses.
  • With equal specific heat and latent heat in the injection and the flash, the flash vessel must return the product to the preheat temperature to remove exactly the water added; the output repeats the preheat temperature.

References

  • Mass and energy balances (definitions)
  • Steam and water properties from IAPWS-IF97

Questions and answers

Why does the vacuum cooler return to preheat temperature?

Flashing to the same temperature removes the condensed steam, so the product's solids are unchanged.

How much water is added?

About 10–12 % for 80 → 145 °C.

Why culinary steam?

It contacts food: filtered, from treated feedwater without non-food amines.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.