FireCADCalc

Milk Fat Standardisation: Cream or Skim to Add

Cream (or skim milk) to add to whole milk to reach a target fat content, and the standardised milk volume, by a fat balance (Pearson square).

Food, dairy and textile

Inputs

Examples: 10 t milk 4.2 % to 3.0 % with skimRaise 3.2 % to 3.5 % with 40 % cream

Results

Stream to add4,067.8kg
Standardised milk14,068kg
Fat in the product422.03kg

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 10 t milk 4.2 % to 3.0 % with skim. The inputs, in the units selected above:

InputValue
Whole milk10,000 kg
Fat in the milk4.2000 %
Fat in the stream to add (cream or skim)0.050000 %
Target fat3.0000 %

Applying the formula below gives:

ResultValue
Stream to add4,067.8 kg
Standardised milk14,068 kg
Fat in the product422.03 kg

Open this example in the calculator and change any input.

Formula

\(M_a = M\frac{f_m - f_t}{f_t - f_a}\)

Variables

Symbol Meaning SI unit
\(M\) Whole milk kg
\(f_m\) Fat in the milk -
\(f_a\) Fat in the stream to add (cream or skim) -
\(f_t\) Target fat -
\(M_a\) Stream to add kg
\(M_t\) Standardised milk kg
\(F\) Fat in the product kg

Method and standards

Fat balance.

Where it is used

  • Market milk and cheese-milk standardisation.

Common mistakes

  • Using litres with mass fractions without density.
  • A target outside the two streams.

Assumptions and limits

  • Fat only; no losses. Adding skim or cream also changes SNF and protein, which are not balanced here; check them against the product standard.

References

  • Mass and energy balances (definitions): fat balance (Pearson square)

Questions and answers

What is the Pearson square?

A graphical form of the fat balance: parts of each stream are the differences between the other stream's fat and the target.

Can I raise fat?

Yes: add cream (fat above target) to milk below the target.

Does SNF change?

Slightly; standardise on fat and check SNF against the product standard.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.