FireCADCalc

Beer Column Stripping Steam (Madson)

Steam to strip ethanol from beer from beer flow, strength and the liquid-to-vapour ratio at the base, per litre of product (Madson, Alcohol Textbook ch. 22).

Distillery and ethanolBoiler

Inputs

Examples: Madson example 1: 100 gpm of 10 % beer, L/V 5Madson example 2: 5 % beer, L/V 6.33

By volume.
Madson: about 5.0 for 10 % beer, 6.33 for 5 % beer.

Results

Madson's examples: 100 gpm of 10 % beer at L/V = 5 takes 9 000 lb/h of steam, 15 lb per gallon of product; 5 % beer at L/V = 6.33 takes 25 lb/gal. 15 lb/gal is 1.80 kg of steam per litre of ethanol.

Water in the beer21,546kg/h
Stripping steam3,403.7kg/h
Ethanol in the beer1,135.6L/h
Steam per litre of ethanol2.9972kg/L

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Madson example 1: 100 gpm of 10 % beer, L/V 5. The inputs, in the units selected above:

InputValue
Beer22.712 m³/h
Ethanol in the beer10.000 %
Liquid / vapour ratio at the base5.0000 -
Density used for the water in the beer998.55 kg/m³

Applying the formula below gives:

ResultValue
Water in the beer20,412 kg/h
Stripping steam4,082.3 kg/h
Ethanol in the beer2,271.2 L/h
Steam per litre of ethanol1.7974 kg/L

Open this example in the calculator and change any input.

Formula

\(L = Q(1 - x)\rho_w, \quad V = \frac{L}{L/V}, \quad \frac{V}{\dot V_E} = \frac{V}{Qx}\)

Variables

Symbol Meaning SI unit
\(Q\) Beer m³/s
\(x\) Ethanol in the beer -
\(L/V\) Liquid / vapour ratio at the base -
\(\rho_w\) Density used for the water in the beer kg/m³
\(L\) Water in the beer kg/s
\(V\) Stripping steam kg/s
\(\dot V_E\) Ethanol in the beer m³/s
\(V/\dot V_E\) Steam per litre of ethanol kg/m³

Method and standards

Madson's simplified stripping balance.

Where it is used

  • Distillation steam estimates.
  • Valuing stronger beer.

Common mistakes

  • Using mass % for volume %.
  • Ignoring the heat to bring the beer to its boiling point.

Assumptions and limits

  • Beer fed at its boiling point; constant molal overflow. The heat to preheat the beer to its boiling point is not included: add it if the beer is fed cold.

References

  • Jacques
  • Lyons and Kelsall (eds.)
  • The Alcohol Textbook
  • 4th ed. (Nottingham University Press, 2003)
  • ch. 22 (Madson)
  • ethanol distillation: the fundamentals
  • Table 1

Questions and answers

Why does weak beer cost more steam?

The column must boil up enough vapour to strip every kilogram of water; weaker beer means more water per litre of ethanol.

What is L/V?

The molar liquid-to-vapour ratio at the column base, where the liquid is nearly all water and the vapour nearly all steam.

Why 500 lb/h per gpm?

Madson's rounding of water at 8.33 lb/gal × 60 min.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.