FireCADCalc

Ohm's Law and Electrical Power Calculator

Voltage, current, resistance and power of a DC circuit or a resistive AC load from any two of them, by Ohm's law V = I R and P = V I.

Electrician and wireman licence examinations

Inputs

Examples: 230 V and 10 A12 V across 4.7 Ω1 kW heater of 52.9 Ω60 W lamp at 12 V

Results

For AC this is a purely resistive load; with reactance use the impedance and P = V I cos φ.

Voltage230.00V
Current4.3478A
Resistance52.900Ω
Power1,000.0W

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 230 V and 10 A. The inputs, in the units selected above:

InputValue
Values you knowVoltage and current
Voltage230.00 V
Current10.000 A
Resistance1.0000 Ω
Power1.0000 W

Applying the formula below gives:

ResultValue
Voltage230.00 V
Current10.000 A
Resistance23.000 Ω
Power2,300.0 W

Open this example in the calculator and change any input.

Formula

\(V = I\, R\)

\(P = V\, I = I^2 R = \frac{V^2}{R}\)

Variables

Symbol Meaning SI unit
\(\text{known}\) Values you know -
\(V\) Voltage V
\(I\) Current A
\(R\) Resistance Ω
\(P\) Power W

Method and standards

Ohm's law relates voltage, current and resistance; power follows from Joule's law. Any two of the four quantities fix the other two.

Where it is used

  • Sizing heaters, resistors and fuses.
  • Checking a resistor's power rating.
  • Finding the resistance of a heating element from its rating.

Common mistakes

  • Using peak instead of rms voltage for AC.
  • Applying it to motors without the power factor.
  • Ignoring the change of resistance with temperature.

Assumptions and limits

  • Only the two values named by the chosen mode are used; the other inputs on the form are ignored.

  • Linear resistance at its working temperature.

  • DC or resistive AC loads.

References

  • Ohm's law (G.S. Ohm, 1827); Joule's law P = V I

Questions and answers

What current does a 2.3 kW heater draw at 230 V?

10 A, and its resistance is 23 Ω.

What power does 12 V across 4.7 Ω give?

2.55 A and 30.6 W, so a 0.25 W resistor would burn out: choose the wattage from P = V²/R.

Does this work for AC?

For resistive loads (heaters, lamps), yes with rms values. Motors and other reactive loads need impedance and power factor.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.