Worked example
Example: 100, 220 and 470 Ω. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Resistor 1 (0 = not used) | 100.00 Ω |
| Resistor 2 (0 = not used) | 220.00 Ω |
| Resistor 3 (0 = not used) | 470.00 Ω |
| Resistor 4 (0 = not used) | 0 Ω |
| Resistor 5 (0 = not used) | 0 Ω |
| Resistor 6 (0 = not used) | 0 Ω |
Applying the formula below gives:
| Result | Value |
|---|---|
| Total resistance, all in series | 790.00 Ω |
| Total resistance, all in parallel | 59.977 Ω |
| Resistors counted | 3.0000 |
| Share of the total current in R₁ (parallel) | 59.977 % |
Open this example in the calculator and change any input.
Formula
\(R_s = \sum R_k\)
\(\frac{1}{R_p} = \sum \frac{1}{R_k}\)
\(\frac{I_1}{I} = \frac{R_p}{R_1}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(R_1\) | Resistor 1 (0 = not used) | Ω |
| \(R_2\) | Resistor 2 (0 = not used) | Ω |
| \(R_3\) | Resistor 3 (0 = not used) | Ω |
| \(R_4\) | Resistor 4 (0 = not used) | Ω |
| \(R_5\) | Resistor 5 (0 = not used) | Ω |
| \(R_6\) | Resistor 6 (0 = not used) | Ω |
| \(R_s\) | Total resistance, all in series | Ω |
| \(R_p\) | Total resistance, all in parallel | Ω |
| \(n\) | Resistors counted | - |
| \(I_1 / I\) | Share of the total current in R₁ (parallel) | - |
Method and standards
From Kirchhoff's laws: resistances in series carry one current and add; in parallel they share one voltage and their conductances add.
Where it is used
- Making an odd resistance value from standard ones.
- Earth electrode groups and parallel cable runs (as a first approximation).
- Current sharing between parallel paths.
Common mistakes
- Adding parallel resistances directly.
- Leaving an unused branch at a small value instead of 0 (not used).
- Using it for impedances with different phase angles.
Assumptions and limits
- Pure resistances (or inductors without mutual coupling).
- Up to six branches.
References
- Kirchhoff's laws (series and parallel combination of resistances)
Questions and answers
What is 100, 220 and 470 Ω in parallel?
60.0 Ω, less than the smallest; in series they make 790 Ω.
What share of the current goes through the 100 Ω branch?
60 %: in parallel each branch carries R_p/R of the total.
And capacitors?
The other way round: capacitors in parallel add; in series their reciprocals add.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.