FireCADCalc

Air-Core Coil Inductance (Wheeler's Formula)

Inductance of a single-layer air-core coil (solenoid) from its diameter, length and turns by Wheeler's formula, and the turns needed for a wanted inductance.

Inputs

Examples: 50 mm diameter, 100 mm long, 100 turns; 1 mH wanted20 mm, 30 mm, 40 turns; 10 µH wanted150 mm, 200 mm, 60 turns; 500 µH

Results

Inductance200.87µH
Turns for the inductance wanted (same diameter and length)223.12
Length to radius ratio4.0000

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 50 mm diameter, 100 mm long, 100 turns; 1 mH wanted. The inputs, in the units selected above:

InputValue
Coil diameter (to the centre of the wire)50.000 mm
Coil length100.00 mm
Number of turns100.00 -
Inductance wanted (to find the turns)1.0000 mH

Applying the formula below gives:

ResultValue
Inductance200.87 µH
Turns for the inductance wanted (same diameter and length)223.12
Length to radius ratio4.0000

Open this example in the calculator and change any input.

Formula

\(L\,[\mu\text{H}] = \frac{r^2 N^2}{9 r + 10 l} \quad (r,\ l\ \text{in inches}), \qquad N_t = \sqrt{\frac{L_t (9r + 10l)}{r^2}}\)

Variables

Symbol Meaning SI unit
\(d\) Coil diameter (to the centre of the wire) m
\(l\) Coil length m
\(N\) Number of turns -
\(L_t\) Inductance wanted (to find the turns) H
\(L\) Inductance H
\(N_t\) Turns for the inductance wanted (same diameter and length) -
\(l/r\) Length to radius ratio -

Method and standards

Wheeler's 1928 empirical fit to the exact current-sheet solution.

Where it is used

  • Chokes and RF coils.
  • Induction and test coils.

Common mistakes

  • Using diameter for radius.
  • Applying it to iron-cored coils.

Assumptions and limits

  • Single layer, air core, l > 0.8 r.

References

  • H.A. Wheeler
  • Simple inductance formulas for radio coils
  • Proc. IRE 16 (1928) 1398

Questions and answers

What is the inductance of 100 turns, 50 mm diameter, 100 mm long?

201 µH.

How accurate is it?

Within about 1 % when the length is more than 0.8 of the radius.

Does wire size matter?

Not in this formula; it treats the winding as a thin current sheet.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.