FireCADCalc

Warp Sizing: Size Add-On and Size Consumption

Size solids added to warp yarn from wet pick-up and size concentration, the add-on percentage, and the size material and water used per day on a sizing machine.

Food, dairy and textile

Inputs

Examples: Pick-up 100 %, 10 % sizePolyester-cotton, 120 %, 8 %

Results

Typical add-on is 8–15 % for cotton; the water picked up must all be dried off on the cylinders.

Size add-on on dry yarn10.000%
Size solids used33.333kg/h
Water evaporated in the drying cylinders300.00kg/h

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Pick-up 100 %, 10 % size. The inputs, in the units selected above:

InputValue
Wet pick-up (size liquor per kg dry yarn)1.0000 kg/kg
Size solids in the liquor10.000 %
Warp yarn through the machine (dry)8.0000 t/d

Applying the formula below gives:

ResultValue
Size add-on on dry yarn10.000 %
Size solids used33.333 kg/h
Water evaporated in the drying cylinders300.00 kg/h

Open this example in the calculator and change any input.

Formula

\(AO = PU\cdot c, \quad \dot M_s = \dot M_y\,AO, \quad \dot M_w = \dot M_y\,PU(1 - c)\)

Variables

Symbol Meaning SI unit
\(PU\) Wet pick-up (size liquor per kg dry yarn) kg/kg
\(c\) Size solids in the liquor -
\(\dot M_y\) Warp yarn through the machine (dry) kg/s
\(AO\) Size add-on on dry yarn -
\(\dot M_s\) Size solids used kg/s
\(\dot M_w\) Water evaporated in the drying cylinders kg/s

Method and standards

Mass balance.

Where it is used

  • Sizing recipes and cost.

Common mistakes

  • Using wet yarn mass.
  • Confusing pick-up with add-on.

Assumptions and limits

  • Steady running.
  • The sized yarn is taken to leave bone dry; in practice it enters and leaves with some regain (moisture), so the water evaporated is slightly overstated.

References

  • Definitions and mass and energy balances

Questions and answers

What is wet pick-up?

Size liquor carried by the yarn after the squeeze rolls, per kg of dry yarn.

How is add-on controlled?

By liquor concentration and squeeze pressure.

Why does it matter?

Too little causes warp breaks; too much wastes size and makes desizing harder.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.