FireCADCalc

Circular Knitting Machine Production

Fabric production of a circular knitting machine from speed, feeders, needles, stitch (loop) length, yarn tex and efficiency.

Food, dairy and textile

Inputs

Examples: 30-inch, 28 gauge, 90 feeders, 25 rpmInterlock 60 feeders 20 rpm

Results

Yarn consumed14,137m/min
Fabric production16.965kg/h

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 30-inch, 28 gauge, 90 feeders, 25 rpm. The inputs, in the units selected above:

InputValue
Machine speed25.000 rpm
Feeders90.000 -
Needles (cylinder)2,640.0 -
Stitch length2.8000 mm
Yarn linear density (tex)20.000 -
Efficiency85.000 %

Applying the formula below gives:

ResultValue
Yarn consumed14,137 m/min
Fabric production16.965 kg/h

Open this example in the calculator and change any input.

Formula

\(\dot L_y = N F n_d \ell\eta, \quad \dot M = \dot L_y T \times 10^{-6}\ \mathrm{kg/m\ per\ tex}\)

Variables

Symbol Meaning SI unit
\(N\) Machine speed 1/s
\(F\) Feeders -
\(n_d\) Needles (cylinder) -
\(\ell\) Stitch length m
\(T\) Yarn linear density (tex = g per 1000 m = 10⁻⁶ kg/m) -
\(\eta\) Efficiency -
\(\dot L_y\) Yarn consumed m/s
\(\dot M\) Fabric production kg/s

Method and standards

Yarn length balance.

Where it is used

  • Knitting capacity planning.

Common mistakes

  • Using loop length in cm.
  • Forgetting efficiency.

Assumptions and limits

  • Single-jersey type; one loop per needle per feeder.

References

  • Definitions and mass and energy balances: yarn knitted = speed × feeders × needles × stitch length

Questions and answers

Why does every needle count on every feeder?

Each feeder lays one course: every needle forms one loop per feeder per revolution.

What output is typical?

A 30-inch single jersey machine makes roughly 15–30 kg/h of 20-tex fabric, depending on speed and stitch length.

What lowers efficiency?

Yarn breaks, doffing and changes; 80–90 % is common.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.