Worked example
Example: Single jersey 18 × 14, 2.8 mm, 20 tex. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Courses per cm | 18.000 - |
| Wales per cm | 14.000 - |
| Loop length | 2.8000 mm |
| Yarn tex | 20.000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Stitch density per cm² | 252.00 |
| Fabric mass per m² | 141.12 g/m² |
| Tightness factor √tex / ℓ(mm) | 1.5972 |
Open this example in the calculator and change any input.
Formula
\(G = c\,w \times 10^4 \cdot \ell \cdot T \times 10^{-6}\ \ (\ell\ \text{in m},\ T\ \text{in tex},\ G\ \text{in kg/m}^2), \quad TF = \frac{\sqrt{T}}{\ell\,[\mathrm{mm}]}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(c\) | Courses per cm | - |
| \(w\) | Wales per cm | - |
| \(\ell\) | Loop length | m |
| \(T\) | Yarn tex | - |
| \(S\) | Stitch density per cm² | - |
| \(G\) | Fabric mass per m² | kg/m² |
| \(TF\) | Tightness factor √tex / ℓ(mm) | - |
Method and standards
Yarn mass per unit area.
Where it is used
- Knit fabric design and costing.
Common mistakes
- Using loop length in cm.
- Measuring stitch density on grey instead of finished fabric.
Assumptions and limits
- Single-jersey structure.
References
- Definitions and mass and energy balances: loops per m² × yarn mass per loop
Questions and answers
Why loops per area?
Each loop uses one loop length of yarn, so mass is loops × length × linear density.
What is tightness factor?
√tex divided by loop length in mm; about 1.4–1.5 for normal single jersey.
Does finishing change GSM?
Yes: relaxation and compaction raise stitch density.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.