FireCADCalc

Spinning Mill Yarn Realisation from Cotton

Yarn realisation from cotton fed to a spinning line from the waste removed at blowroom, carding, combing and later processes, with the cotton needed per kg of yarn.

Food, dairy and textile

Inputs

Examples: Combed yarnCarded yarn

Each waste share is on the material entering that process, not on the cotton fed to the mill.

Results

Each waste share applies to the material entering that process, so the losses multiply.

Yarn produced7,507.6kg
Yarn realisation75.076%
Cotton per kg of yarn1.3320kg/kg

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Combed yarn. The inputs, in the units selected above:

InputValue
Cotton (lint) fed10,000 kg
Blowroom waste4.0000 %
Card waste5.0000 %
Comber noil (0 for carded yarn)16.000 %
Waste in later processes (draw frame to winding)2.0000 %

Applying the formula below gives:

ResultValue
Yarn produced7,507.6 kg
Yarn realisation75.076 %
Cotton per kg of yarn1.3320 kg/kg

Open this example in the calculator and change any input.

Formula

\(R = (1 - w_b)(1 - w_c)(1 - w_{cb})(1 - w_o), \quad Y = MR\)

Variables

Symbol Meaning SI unit
\(M\) Cotton (lint) fed kg
\(w_b\) Blowroom waste -
\(w_c\) Card waste -
\(w_{cb}\) Comber noil (0 for carded yarn) -
\(w_o\) Waste in later processes (draw frame to winding) -
\(Y\) Yarn produced kg
\(R\) Yarn realisation -
\(M/Y\) Cotton per kg of yarn kg/kg

Method and standards

Sequential mass balance.

Where it is used

  • Spinning mill costing.
  • Cotton purchasing.

Common mistakes

  • Adding waste percentages.
  • Ignoring moisture differences.

Assumptions and limits

  • Same moisture basis throughout.
  • Each waste share is on the input to its own process. Mill figures quoted on cotton fed must be converted first (or simply subtracted from 100 % for the realisation).

References

  • Definitions and mass and energy balances: each waste share on the input to its process

Questions and answers

What realisation is typical?

Carded yarn about 85–88 %; combed yarn about 72–76 % with 15–18 % noil.

Why multiply the shares?

Waste at each stage is taken from what that stage receives, not from the original cotton.

Is waste lost?

Much is sold or reused in coarser yarns; it still lowers realisation.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.