FireCADCalc

Ply (Folded) Yarn Resultant Count

Resultant linear density of a ply yarn from up to three component yarns in tex or Ne, with an allowance for twist take-up (contraction) on plying.

Food, dairy and textile

Inputs

Examples: 2/40s Ne, 2 % contraction3-ply 20 + 20 + 30 tex

Results

Resultant linear density72.165tex
Resultant Ne8.1832

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 2/40s Ne, 2 % contraction. The inputs, in the units selected above:

InputValue
Counts entered inNe (English cotton)
Yarn 1 count40.000 -
Yarn 2 count40.000 -
Yarn 3 count (0 = none)0 -
Twist contraction on plying2.0000 %

Applying the formula below gives:

ResultValue
Resultant linear density30.130 tex
Resultant Ne19.600

Open this example in the calculator and change any input.

Formula

\(T_R = \frac{\sum T_i}{1 - c_t}, \quad Ne_R = \frac{590.54}{T_R}, \quad 590.54 = \frac{453.59237\ \mathrm{g}}{840 \times 0.9144\ \mathrm{m}} \times 1000\)

Variables

Symbol Meaning SI unit
\(\text{system}\) Counts entered in -
\(N_1\) Yarn 1 count -
\(N_2\) Yarn 2 count -
\(N_3\) Yarn 3 count (0 = none) -
\(c_t\) Twist contraction on plying -
\(T_R\) Resultant tex (g per km) -
\(Ne_R\) Resultant Ne -

Method and standards

Linear density definitions.

Where it is used

  • Yarn specification and costing.

Common mistakes

  • Adding Ne counts directly.
  • Ignoring contraction.

Assumptions and limits

  • Contraction as a length share.
  • Yarn 3 is either 0 (none) or a real count of at least 0.5.
  • Tex is shown as a plain number in g/km.

References

  • Definitions and mass and energy balances: tex adds directly; Ne combines as 1/ΣNe⁻¹; plying twist shortens the yarn

Questions and answers

What is 2/40s?

Two 40s Ne singles plied: about 20s Ne resultant before contraction.

Why does contraction raise the tex?

Plying twist shortens the yarn, so the same mass occupies less length.

Can I mix counts?

Yes; tex simply adds.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.