FireCADCalc

Paddy Drying: Water Removed and Heat

Water to remove when paddy is dried from harvest to storage moisture (wet basis), the dried paddy mass, and the heat and fuel at a specific heat use per kg water.

Food, dairy and textile

Inputs

Examples: 10 t from 24 % to 14 %Parboiled paddy 32 % to 14 %

Use your dryer's measured figure; the default 5 MJ/kg is a typical mid value for batch and recirculating dryers, not a sourced constant.

Results

Dry in stages with tempering below 40–45 °C grain temperature to avoid fissures and low head rice yield.

Dried paddy15,814kg
Water removed4,186.0kg
Heat18.837GJ
Fuel1,345.5kg

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 10 t from 24 % to 14 %. The inputs, in the units selected above:

InputValue
Wet paddy10,000 kg
Harvest moisture (wet basis)24.000 %
Storage moisture (wet basis)14.000 %
Heat per kg of water removed5.0000 MJ/kg
Fuel (husk) heating value14.000 MJ/kg

Applying the formula below gives:

ResultValue
Dried paddy8,837.2 kg
Water removed1,162.8 kg
Heat5.8140 GJ
Fuel415.28 kg

Open this example in the calculator and change any input.

Formula

\(M_2 = M\frac{1 - w_1}{1 - w_2}, \quad M_w = M - M_2, \quad Q = M_w q, \quad M_f = \frac{Q}{LHV}\)

Variables

Symbol Meaning SI unit
\(M\) Wet paddy kg
\(w_1\) Harvest moisture (wet basis) -
\(w_2\) Storage moisture (wet basis) -
\(q\) Heat per kg of water removed J/kg
\(LHV\) Fuel (husk) heating value J/kg
\(M_2\) Dried paddy kg
\(M_w\) Water removed kg
\(Q\) Heat J
\(M_f\) Fuel kg

Method and standards

Dry matter balance.

Where it is used

  • Rice mill dryer sizing.
  • Procurement shrink allowances.

Common mistakes

  • Subtracting moisture percentages directly.
  • Mixing wet and dry basis.

Assumptions and limits

  • No dry matter loss.
  • The heat per kg of water removed is the user's figure; the default 5 MJ/kg is a typical value, not from a cited source.

References

  • Definitions and mass and energy balances: dry matter balance on wet-basis moisture

Questions and answers

Why does weight drop more than the moisture points suggest?

Wet-basis moisture is per kg of wet grain: 24 % to 14 % removes 11.6 % of the mass.

What heat use is typical?

4–6 MJ per kg of water in batch and recirculating dryers.

Why not dry fast?

Rapid drying cracks kernels and cuts head rice yield.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.