FireCADCalc

Loom Production: Metres and Picks per Hour

Fabric production of a loom from speed in picks per minute, picks per cm and efficiency, with the picks inserted per hour and fabric mass per hour.

Food, dairy and textile

Inputs

Examples: Air-jet 700 ppm, 30 picks/cmRapier 450 ppm

Results

Fabric produced10.432m/h
Picks inserted per hour22,950
Fabric mass4.4335kg/h

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Air-jet 700 ppm, 30 picks/cm. The inputs, in the units selected above:

InputValue
Loom speed (picks per minute)700.00 -
Picks per cm30.000 -
Loom efficiency88.000 %
Fabric mass per m²120.00 g/m²
Fabric width1.9000 m

Applying the formula below gives:

ResultValue
Fabric produced12.320 m/h
Picks inserted per hour36,960
Fabric mass2.8090 kg/h

Open this example in the calculator and change any input.

Formula

\(L = \frac{60\,n\,\eta}{100\,n_p}\ \ (L\ \text{in m/h},\ n\ \text{in picks/min},\ n_p\ \text{in picks/cm}), \quad n_h = 60\,n\,\eta, \quad \dot m = L\,W\,G\)

Variables

Symbol Meaning SI unit
\(n\) Loom speed (picks per minute) -
\(n_p\) Picks per cm -
\(\eta\) Loom efficiency -
\(G\) Fabric mass per m² kg/m²
\(W\) Fabric width m
\(L\) Fabric produced m/s
\(n_h\) Picks inserted per hour -
\(\dot m\) Fabric mass kg/s

Method and standards

Weaving production definition.

Where it is used

  • Weaving capacity planning.

Common mistakes

  • Using picks per inch as per cm.
  • Ignoring efficiency.

Assumptions and limits

  • Steady running.

References

  • Definitions and mass and energy balances

Questions and answers

What speed do air-jet looms reach?

800–1,200 picks per minute; rapiers 500–700.

Why use picks per cm?

Fabric length = picks inserted / pick density.

What efficiency is good?

85–92 % on modern looms.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.