FireCADCalc

Oil and Gas in Place by the Volumetric Method

Stock-tank oil or standard gas initially in place from drainage area, net pay, porosity, water saturation and formation volume factor, and recoverable volume.

Process steam and utilitiesRefinery and petrochemicalChemical and fertiliser

Inputs

Examples: 640 acres, 30 ft oil zoneGas zone, B_gi 0.005

Results

Oil: the result is stock-tank m³ (1 m³ = 6.29 bbl).

Hydrocarbon pore volume3,552,428m³
Volume in place at surface (stock-tank oil or standard gas)2,732,637m³
Recoverable volume819,791m³

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 640 acres, 30 ft oil zone. The inputs, in the units selected above:

InputValue
Reservoir fluidOil
Drainage area259.00 ha
Net pay thickness9.1440 m
Porosity20.000 %
Initial water saturation25.000 %
Initial formation volume factor (B_oi, or B_gi in reservoir m³ per standard m³)1.3000 -
Recovery factor30.000 %

Applying the formula below gives:

ResultValue
Hydrocarbon pore volume3,552,428 m³
Volume in place at surface (stock-tank oil or standard gas)2,732,637 m³
Recoverable volume819,791 m³

Open this example in the calculator and change any input.

Formula

\(V_p = Ah\phi(1 - S_{wi}), \quad N = \frac{V_p}{B_i}, \quad N_r = N\cdot RF\)

Variables

Symbol Meaning SI unit
\(\text{fluid}\) Reservoir fluid -
\(A\) Drainage area m²
\(h\) Net pay thickness m
\(\phi\) Porosity -
\(S_{wi}\) Initial water saturation -
\(B_i\) Initial formation volume factor (B_oi, or B_gi in reservoir m³ per standard m³) -
\(RF\) Recovery factor -
\(V_p\) Hydrocarbon pore volume m³
\(N\) Volume in place at surface (stock-tank oil or standard gas) m³
\(N_r\) Recoverable volume m³

Method and standards

Volumetric balance.

Where it is used

  • Early reserve estimates.
  • Checking material-balance results.

Common mistakes

  • Using gross instead of net pay.
  • Mixing reservoir and surface units for B_g.

Assumptions and limits

  • Uniform average properties.

References

  • Ahmed
  • Reservoir Engineering Handbook
  • 5th ed. (Gulf Professional Publishing, 2019)
  • ch. 4 and ch. 13 (volumetric method)

Questions and answers

Why divide by the formation volume factor?

It converts the reservoir volume of oil or gas to surface (stock-tank or standard) volume.

What recovery factor is typical?

About 5–30 % for oil on primary depletion, more with waterflood; 50–90 % for gas.

What do the defaults represent?

A 640-acre, 30 ft oil zone with 20 % porosity, 25 % water and B_oi = 1.3.

Method and article reviewed by FireCAD engineering on 17 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.