FireCADCalc

Whey or Milk RO Concentration: Permeate and Retentate

Permeate and retentate flows, volume concentration factor and retentate solids of a reverse osmosis or nanofiltration plant from feed, solids and solids rejection.

Food, dairy and textile

Inputs

Examples: 20 m3/h whey 6 % to 18 %Milk RO to 2x

Results

Permeate solids are estimated from the rejection at feed concentration; real permeate gets richer as the retentate concentrates.

Retentate solids above about 22 %: beyond the usual practical limit of RO for whey (osmotic pressure and fouling); consider evaporation for the rest.

Retentate14.962m³/h
Permeate15.038m³/h
Volume concentration factor2.0050
Permeate solids0.062500%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 20 m3/h whey 6 % to 18 %. The inputs, in the units selected above:

InputValue
Feed20.000 m³/h
Feed total solids6.0000 %
Target retentate solids18.000 %
Solids rejection99.000 %

Applying the formula below gives:

ResultValue
Retentate6.6221 m³/h
Permeate13.378 m³/h
Volume concentration factor3.0202
Permeate solids0.060000 %

Open this example in the calculator and change any input.

Formula

\(x_P = x_F(1 - R), \quad \dot V_R = \dot V_F\frac{x_F - x_P}{x_R - x_P}, \quad VCF = \frac{\dot V_F}{\dot V_R}\)

Variables

Symbol Meaning SI unit
\(\dot V_F\) Feed m³/s
\(x_F\) Feed total solids -
\(x_R\) Target retentate solids -
\(R\) Solids rejection -
\(\dot V_R\) Retentate m³/s
\(\dot V_P\) Permeate m³/s
\(VCF\) Volume concentration factor -
\(x_P\) Permeate solids -

Method and standards

Solids balance (densities taken equal).

Where it is used

  • Membrane plant sizing.

Common mistakes

  • Ignoring density differences at high solids.

Assumptions and limits

  • Equal densities; constant rejection. An 18 % concentrate is several per cent denser than permeate, so the retentate volume is slightly overstated.
  • Retentate solids above about 22 %, the practical RO limit for whey quoted in the FAQ, are flagged.

References

  • Mass and energy balances (definitions): solids balance with a solids rejection

Questions and answers

Why concentrate whey by RO?

It removes water at a fraction of the energy of evaporation, cutting transport and drying cost.

How far can RO go?

About 18–22 % solids for whey before osmotic pressure and fouling limit it.

What is VCF?

Feed volume divided by retentate volume.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.