Worked example
Example: 300 µm sand into an 850 °C bed. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Particle specific heat | 0.84000 kJ/(kg·K) |
| Particle density | 2,500.0 kg/m³ |
| Mean particle diameter (surface-volume) | 0.30000 mm |
| Gas-to-particle heat transfer coefficient | 200.00 W/(m²·K) |
| Bed (gas) temperature | 850.00 °C |
| Initial particle temperature | 30.000 °C |
| Particle temperature to reach | 800.00 °C |
| Particle thermal conductivity | 1.5000 W/(m·K) |
Applying the formula below gives:
| Result | Value |
|---|---|
| Time to reach T_p | 1.4686 s |
| Time to close 99 % of the gap | 2.4097 s |
| Biot number h d_p/(6 k_p) | 0.006667 |
Open this example in the calculator and change any input.
Formula
\(t = \frac{C_p\rho_pd_p}{6h_{gp}}\ln\frac{T_g - T_{p0}}{T_g - T_p}, \quad t_{99\%} = 0.765\frac{C_p\rho_pd_p}{h_{gp}}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(C_p\) | Particle specific heat | J/(kg·K) |
| \(\rho_p\) | Particle density | kg/m³ |
| \(d_p\) | Mean particle diameter (surface-volume) | m |
| \(h_{gp}\) | Gas-to-particle heat transfer coefficient | W/(m²·K) |
| \(T_g\) | Bed (gas) temperature | K |
| \(T_{p0}\) | Initial particle temperature | K |
| \(T_p\) | Particle temperature to reach | K |
| \(t\) | Time to reach T_p | s |
| \(t_{99\%}\) | Time to close 99 % of the gap | s |
| \(k_p\) | Particle thermal conductivity | W/(m·K) |
| \(Bi\) | Biot number h d_p/(6 k_p) | - |
Method and standards
Lumped-capacity heating of a sphere.
Where it is used
- Fuel feeding and combustion studies.
Common mistakes
- Using the lumped model for large lumps.
Assumptions and limits
- Uniform particle temperature; constant h.
- Valid only for a Biot number Bi = h d_p / (6 k_p) below about 0.1, which the calculator shows and warns about. For coarse coal of several millimetres internal conduction slows heating and the time shown is too short.
References
- Basu
- Circulating Fluidized Bed Boilers: Design
- Operation and Maintenance (Springer, 2015)
- ch. 3
- Eqs. (3.3) and (3.4) (lumped particle heating)
Questions and answers
Why so fast?
Small particles have little mass per surface: a 300 µm sand grain closes 99 % of the gap in about 2–3 s at h = 200 W/m²·K.
Why 0.765?
It is Basu's coefficient for the time to close 99 % of the gap for a sphere with lumped capacity; ln(100)/6 = 0.768, so the two agree within 0.3 %.
Is the lumped model valid?
For small particles (Biot number < 0.1); large coal lumps heat more slowly inside.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.