FireCADCalc

Condensate Polishing Unit: Permeate and Reject

Permeate and reject flows and COD of a condensate polishing (RO) unit from the condensate flow, the recovery, the feed COD and the membrane rejection.

Distillery and ethanolWater treatment plant

Inputs

Examples: 650 m3/d at 85 %Two-pass recovery

Results

The reject usually returns to the evaporator; check its COD against what the evaporator can take.

Permeate360.00m³/d
Reject40.000m³/d
Permeate COD75.000mg/L
Reject COD24,325mg/L

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 650 m3/d at 85 %. The inputs, in the units selected above:

InputValue
Process condensate650.00 m³/d
Recovery (permeate / feed)85.000 %
Feed COD1,500.0 mg/L
COD rejection by the membranes95.000 %

Applying the formula below gives:

ResultValue
Permeate552.50 m³/d
Reject97.500 m³/d
Permeate COD75.000 mg/L
Reject COD9,575.0 mg/L

Open this example in the calculator and change any input.

Formula

\(\dot V_p = \dot V R, \quad c_p = c_f (1 - \rho_r), \quad c_r = \frac{\dot V c_f - \dot V_p c_p}{\dot V - \dot V_p}\)

Variables

Symbol Meaning SI unit
\(\dot V\) Process condensate m³/s
\(R\) Recovery (permeate / feed) -
\(c_f\) Feed COD kg/m³
\(\rho_r\) COD rejection by the membranes -
\(\dot V_p\) Permeate m³/s
\(\dot V_r\) Reject m³/s
\(c_p\) Permeate COD kg/m³
\(c_r\) Reject COD kg/m³

Method and standards

Mass balance.

Where it is used

  • CPU sizing.
  • ZLD balance.

Common mistakes

  • Rejection applied to the reject.

Assumptions and limits

  • Single stage.
  • The rejection is applied to the feed COD. In a real RO stage the permeate follows the mean feed-side concentration, which rises with recovery, so at high recovery the permeate COD here is understated and the reject COD overstated.

References

  • Flow and solute balance across a membrane stage with a rejection

Questions and answers

Why polish condensate?

Evaporator condensate carries volatile organics; polished, it replaces fresh water.

Recovery limit?

Fouling and the reject's strength; 80–90 % is common.

Rejection?

The share of COD the membrane holds back; volatile acids pass more easily.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.