FireCADCalc

Sugar Warehouse Capacity

Tonnes and bags of sugar a warehouse holds from the floor area, the share usable for stacks, the stack height and the stacking density.

Sugar mill and cogeneration

Inputs

Examples: 3000 m2 godown1 t big bags

Results

Floor load under the stacks is about 33 kPa: check it against the floor's rating.

The usable share (70 %) and stacking density (800 kg/m³) defaults are typical figures, not from a cited source: use your own.

Capacity3,290.6t
Bags3,290.0

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 3000 m2 godown. The inputs, in the units selected above:

InputValue
Floor area3,000.0 m²
Share of floor usable for stacks70.000 %
Stack height6.0000 m
Stacking density of bagged sugar800.00 kg/m³
Bag mass50.000 kg

Applying the formula below gives:

ResultValue
Capacity10,080 t
Bags201,600

Open this example in the calculator and change any input.

Formula

\(M = A\,u\,H\,\rho_s, \quad N_b = \left\lfloor\frac{M}{m_b}\right\rfloor\)

Variables

Symbol Meaning SI unit
\(A\) Floor area m²
\(u\) Share of floor usable for stacks -
\(H\) Stack height m
\(\rho_s\) Stacking density of bagged sugar kg/m³
\(m_b\) Bag mass kg
\(M\) Capacity kg
\(N_b\) Bags -

Method and standards

Definitions.

Where it is used

  • Warehouse planning.
  • Season stock planning.

Common mistakes

  • Full floor area used.

Assumptions and limits

  • Uniform stacks.
  • The default usable share and stacking density are typical figures, not from a cited source.
  • The floor load ρ_s H g is shown in a note; check it against the floor rating, especially for high stacks.

References

  • Volume × stacking density; usable share and density by practice

Questions and answers

Why only part of the floor?

Gangways, fire lanes and clearances from walls take space.

Stacking density?

Bagged sugar in stacks is roughly 0.75–0.85 t/m³; measure for your bags.

Days of storage?

Divide capacity by sugar made per day.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.