FireCADCalc

Sugar Dryer: Water Removed and Air Flow

Water removed in a sugar dryer from the sugar flow and moisture in and out, and the dry-air flow from the humidity rise of the air.

Sugar mill and cogeneration

Inputs

Examples: 25 t/h, 1 % to 0.05 %Refined sugar

Used only to check that the exit humidity is below saturation at 1 atm.

Results

Water removed92.428kg/h
Dry air needed18,486kg/h

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 25 t/h, 1 % to 0.05 %. The inputs, in the units selected above:

InputValue
Wet sugar to dryer25.000 t/h
Moisture in (wet basis)1.0000 %
Moisture out (wet basis)0.050000 %
Air humidity in8.0000 g/kg
Air humidity out12.000 g/kg
Air temperature out (to check saturation)40.000 °C

Applying the formula below gives:

ResultValue
Water removed237.62 kg/h
Dry air needed59,405 kg/h

Open this example in the calculator and change any input.

Formula

\(\dot m_w = \dot m (1 - w_1)\left(\frac{w_1}{1-w_1} - \frac{w_2}{1-w_2}\right), \quad \dot m_a = \frac{\dot m_w}{Y_2 - Y_1}\)

Variables

Symbol Meaning SI unit
\(\dot m\) Wet sugar to dryer kg/s
\(w_1\) Moisture in (wet basis) -
\(w_2\) Moisture out (wet basis) -
\(Y_1\) Air humidity in kg/kg
\(Y_2\) Air humidity out kg/kg
\(T_e\) Air temperature out (to check saturation) K
\(\dot m_w\) Water removed kg/s
\(\dot m_a\) Dry air needed kg/s

Method and standards

Mass balance.

Where it is used

  • Dryer and cooler sizing.

Common mistakes

  • Wet and dry basis mixed.

Assumptions and limits

  • Steady state.
  • The exit humidity must be below saturation at the exit air temperature (checked at 1 atm).

References

  • Solids and moisture balance; air humidity balance (psychrometrics)

Questions and answers

Why so little water?

Sugar leaves the centrifugals with about 0.5–1.5 % moisture.

Why does it matter?

Moist sugar cakes and grows microbes in storage.

Air heated?

Heating raises the humidity it can take; then it needs a cooler stage.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.