FireCADCalc

Sugar Colour in ICUMSA Units

Colour of a sugar solution in ICUMSA units from its absorbance, the cell length and the solution's concentration from brix and density.

Sugar mill and cogeneration

Inputs

Examples: White sugar 50 brixRaw sugar, 1 cm cell

Results

Absorbance outside about 0.2–0.8: the photometer reading is less precise; change the cell length or the dilution.

Use the density of the solution at the measured brix; the ICUMSA method fixes pH, filtration and wavelength.

Concentration (g of solids per mL)0.61500
Colour, ICUMSA units1,382.1

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: White sugar 50 brix. The inputs, in the units selected above:

InputValue
Absorbance at 420 nm (filtered, pH adjusted)0.12000 -
Cell length1.0000 cm
Solution brix50.000 %
Solution density1,230.0 kg/m³

Applying the formula below gives:

ResultValue
Concentration (g of solids per mL)0.61500
Colour, ICUMSA units195.12

Open this example in the calculator and change any input.

Formula

\(IU = \frac{1000\,A}{b\,c}, \quad c = \frac{Bx\,\rho}{1000}\)

Variables

Symbol Meaning SI unit
\(A\) Absorbance at 420 nm (filtered, pH adjusted) -
\(b\) Cell length m
\(Bx\) Solution brix -
\(\rho\) Solution density kg/m³
\(c\) Concentration (g of solids per mL) -
\(IU\) Colour, ICUMSA units -

Method and standards

ICUMSA definition.

Where it is used

  • Grading plantation white and refined sugar.
  • Process colour control.

Common mistakes

  • Cell length in mm.
  • Brix without density.

Assumptions and limits

  • Method conditions as ICUMSA.
  • Brix and density are separate inputs and are not checked against each other: enter the density that belongs to the brix (for example from a sucrose density table).
  • A note appears for absorbances outside about 0.2–0.8, where photometer readings are less precise.

References

  • ICUMSA colour definition: IU = 1000 A/(b c)
  • b in cm
  • c in g/mL (ICUMSA Methods GS2/3-10 and GS1/3-7)

Questions and answers

What does 1000 in the formula do?

It scales the attenuation index to the familiar ICUMSA unit.

Why concentration in g/mL?

The definition divides by solids per millilitre, so brix times density/1000.

Why pH 7 and 420 nm?

Colour depends on pH and wavelength; the method fixes both.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.