FireCADCalc

Von Mises Equivalent Stress and Factor of Safety

Von Mises (distortion energy) equivalent stress from plane-stress components, and the factor of safety against yield by von Mises and by Tresca.

Inputs

Examples: σx 120, σy 40, τ 50 MPa, Sy 250Pure shear 80 MPa, Sy 300Biaxial tension 150 and 100 MPa, Sy 350

Results

Ductile materials under static load. Tresca is slightly conservative compared with von Mises.

Von Mises stress132.29MPa
Factor of safety by von Mises S_y/σ'2.6458
Tresca equivalent stress (largest principal difference)150.00MPa
Factor of safety by Tresca2.3333

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: σx 120, σy 40, τ 50 MPa, Sy 250. The inputs, in the units selected above:

InputValue
Normal stress in x120.00 MPa
Normal stress in y40.000 MPa
Shear stress50.000 MPa
Yield strength250.00 MPa

Applying the formula below gives:

ResultValue
Von Mises stress136.75 MPa
Factor of safety by von Mises S_y/σ'1.8282
Tresca equivalent stress (largest principal difference)144.03 MPa
Factor of safety by Tresca1.7357

Open this example in the calculator and change any input.

Formula

\(\sigma' = \sqrt{\sigma_x^2 - \sigma_x\sigma_y + \sigma_y^2 + 3\tau_{xy}^2}, \quad n = \frac{S_y}{\sigma'}\)

\(\sigma_T = \max(|\sigma_1 - \sigma_2|, |\sigma_1|, |\sigma_2|)\)

Variables

Symbol Meaning SI unit
\(\sigma_x\) Normal stress in x Pa
\(\sigma_y\) Normal stress in y Pa
\(\tau_{xy}\) Shear stress Pa
\(S_y\) Yield strength Pa
\(\sigma'\) Von Mises stress Pa
\(n_{vm}\) Factor of safety by von Mises S_y/σ' -
\(\sigma_{T}\) Tresca equivalent stress (largest principal difference) Pa
\(n_{T}\) Factor of safety by Tresca -

Method and standards

Distortion energy and maximum shear stress criteria.

Where it is used

  • Static design checks.
  • FEA result interpretation.

Common mistakes

  • Using it for brittle materials.
  • Ignoring stress concentration in fatigue.

Assumptions and limits

  • Plane stress, ductile material.

References

  • Shigley's Mechanical Engineering Design (Budynas and Nisbett)
  • ch. 5 (distortion energy and maximum shear stress theories)

Questions and answers

σx 120, σy 40, τ 50 MPa with a 250 MPa yield?

σ' = 136.7 MPa, factor of safety 1.83.

What about pure shear?

σ' = √3 τ: yield in shear is 0.577 S_y.

Why does Tresca use three principals?

The out-of-plane principal stress is zero and can give the largest difference.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.