Worked example
Example: 50 MPa, 100 / 150 mm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Internal pressure | 50.000 MPa |
| Inner radius | 100.00 mm |
| Outer radius | 150.00 mm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Hoop stress at the inner surface | 56.579 MPa |
| Hoop stress at the outer surface | 31.579 MPa |
| Radial stress at the inner surface (−p) | -50.000 MPa |
| Thin-wall hoop stress p r_i/(2t) | 50.000 MPa |
| Stress intensity at the inner surface (Tresca) | 106.58 MPa |
Open this example in the calculator and change any input.
Formula
\(\sigma_t(r) = \frac{p\, r_i^3 (r_o^3 + 2r^3)}{2 r^3 (r_o^3 - r_i^3)}, \quad \sigma_r(r) = -\frac{p\, r_i^3 (r_o^3 - r^3)}{r^3 (r_o^3 - r_i^3)}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(p\) | Internal pressure | Pa |
| \(r_i\) | Inner radius | m |
| \(r_o\) | Outer radius | m |
| \(\sigma_{t,i}\) | Hoop stress at the inner surface | Pa |
| \(\sigma_{t,o}\) | Hoop stress at the outer surface | Pa |
| \(\sigma_{r,i}\) | Radial stress at the inner surface (−p) | Pa |
| \(\sigma_{thin}\) | Thin-wall hoop stress p r_i/(2t) | Pa |
| \(\sigma_{t,i} - \sigma_{r,i}\) | Stress intensity at the inner surface (Tresca) | Pa |
Method and standards
Lamé solution for spherical symmetry.
Where it is used
- High-pressure spheres and heads.
- Strength of materials examinations.
Common mistakes
- Using cylinder formulas.
- Diameter for radius.
Assumptions and limits
The stress intensity σ_t − σ_r at the inner surface is the Tresca equivalent stress; no yield or code check is made.
Elastic, internal pressure only.
References
- Lamé solution for a thick sphere (Timoshenko and Goodier, Theory of Elasticity)
Questions and answers
50 MPa in a sphere of 100 and 150 mm radii?
Inner hoop stress 56.6 MPa; thin-wall theory gives 50 MPa.
Why does a sphere need half the thickness of a cylinder?
Its hoop stress is half the cylinder's for the same pressure and radius.
When is thin-wall theory fine?
Wall thickness under about a tenth of the radius.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.