Worked example
Example: σa 80, σm 120; Se 200, Sut 600, Sy 400. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Alternating stress | 80.000 MPa |
| Mean stress (negative = compressive) | 120.00 MPa |
| Endurance limit (corrected for size, surface, etc.) | 200.00 MPa |
| Ultimate tensile strength | 600.00 MPa |
| Yield strength | 400.00 MPa |
Applying the formula below gives:
| Result | Value |
|---|---|
| Factor of safety, Goodman | 1.6667 |
| Factor of safety, Soderberg | 1.4286 |
| Factor of safety, Gerber | 2.0711 |
| Factor of safety against first-cycle yield S_y/(σ_a + σ_m) | 2.0000 |
Open this example in the calculator and change any input.
Formula
\(\frac{1}{n_G} = \frac{\sigma_a}{S_e} + \frac{\sigma_m}{S_{ut}}, \quad \frac{1}{n_S} = \frac{\sigma_a}{S_e} + \frac{\sigma_m}{S_y}\)
\(\frac{n\sigma_a}{S_e} + \left(\frac{n\sigma_m}{S_{ut}}\right)^2 = 1\ (\text{Gerber})\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\sigma_a\) | Alternating stress | Pa |
| \(\sigma_m\) | Mean stress (negative = compressive) | Pa |
| \(S_e\) | Endurance limit (corrected for size, surface, etc.) | Pa |
| \(S_{ut}\) | Ultimate tensile strength | Pa |
| \(S_y\) | Yield strength | Pa |
| \(n_G\) | Factor of safety, Goodman | - |
| \(n_S\) | Factor of safety, Soderberg | - |
| \(n_{Ger}\) | Factor of safety, Gerber | - |
| \(n_y\) | Factor of safety against first-cycle yield S_y/(σ_a + σ_m) | - |
Method and standards
Mean-stress fatigue criteria along a proportional load line.
Where it is used
- Shafts, springs and bolts under cyclic loads.
- Machine design examinations.
Common mistakes
- Using the uncorrected endurance limit.
- Ignoring stress concentration.
Assumptions and limits
- Proportional loading, infinite life.
- S_y and S_e may not exceed S_ut.
- For a compressive mean stress all three fatigue factors are S_e/σ_a and the yield factor uses |σ_m|.
- The design factor is the smaller of the fatigue factor and n_y.
References
- Shigley's Mechanical Engineering Design (Budynas and Nisbett)
- ch. 6 (fluctuating stresses: modified Goodman, Soderberg, Gerber)
Questions and answers
σa 80, σm 120 MPa; Se 200, Sut 600, Sy 400 MPa?
Goodman 1.67, Soderberg 1.43.
Which line should I use?
Goodman for design; Soderberg when yielding must be avoided with margin.
Where does S_e come from?
The test endurance limit times the Marin factors for surface, size, load, temperature and reliability.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.