Worked example
Example: 100 kN at 10 mm on a 150 mm section, 3 m. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Axial load | 100.00 kN |
| Eccentricity of the load | 10.000 mm |
| Cross-sectional area | 2,850.0 mm² |
| Radius of gyration about the bending axis | 41.500 mm |
| Distance from the axis to the extreme fibre | 75.000 mm |
| Effective length | 3.0000 m |
| Young's modulus | 207.00 GPa |
Applying the formula below gives:
| Result | Value |
|---|---|
| Eccentricity ratio | 0.43548 |
| Secant argument | 0.47058 |
| Maximum compressive stress | 52.231 MPa |
| Direct stress | 35.088 MPa |
Open this example in the calculator and change any input.
Formula
\(\sigma_{max} = \frac{P}{A}\left[1 + \frac{e c}{k^2} \sec\left(\frac{L_e}{2k}\sqrt{\frac{P}{AE}}\right)\right]\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(P\) | Axial load | N |
| \(e\) | Eccentricity of the load | m |
| \(A\) | Cross-sectional area | m² |
| \(k\) | Radius of gyration about the bending axis | m |
| \(c\) | Distance from the axis to the extreme fibre | m |
| \(L_e\) | Effective length | m |
| \(E\) | Young's modulus | Pa |
| \(ec/k^2\) | Eccentricity ratio | - |
| \(\frac{L_e}{2k}\sqrt{\frac{P}{AE}}\) | Secant argument | - |
| \(\sigma_{max}\) | Maximum compressive stress | Pa |
| \(P/A\) | Direct stress | Pa |
Method and standards
Elastic bending of a column with eccentric load.
Where it is used
- Brackets and offset-loaded columns.
- Strength of materials examinations.
Common mistakes
- Wrong bending axis.
- Ignoring accidental eccentricity.
Assumptions and limits
- Elastic, pin-ended effective length.
- σ_max is not compared with the yield strength and no factor of safety is applied: check σ_max against your allowable, or solve for the load that makes it reach yield divided by the factor.
References
- Shigley's Mechanical Engineering Design (Budynas and Nisbett)
- ch. 4 (secant column formula)
Questions and answers
Why does eccentricity matter so much?
The bending moment grows as the column bows, through the secant term.
What if there is no eccentricity?
The stress is P/A until buckling.
How is it used in design?
Find the load that makes σ_max equal yield, then apply a factor of safety.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.